ON STAGE 400P (serv.man4) - JBL Audio EMC - CB Certificate (repair manual). Page 75

 

- 

Page 3 of 7

 - 

 

 

 

Report No.  100711 

 

 

 

Earthing of CLASS 0I EQUIPMENT 

Plugs with a lead wire for earthing shall not be used for 
equipment having a rated voltage exceeding 150V. 

For plugs with a lead wire for earthing, the lead wire 
shall not be earthed by a clip. 

CLASS 0I EQUIPMENT shall be provided with an 
earthing terminal or lead wire for earthing in the 
external where easily visible. 

Class III equipment. 
 

N 

Delete 1) in Table 3B. 

Considered. 

 

 

Add the following informative remark after the last 
sentence. 

Remark - IEC 61965 is also applicable instead of IEC 
60065. 

Considered. 

 

 

Add the following to suffix 5) as specified in 
“Conditions applicable to Table 4A, Parts 1 and 2”. 

With regard to Table 4A, insulating materials 
complying with Japanese requirements (refer to 
Japanese differences for the current IEC 60335-1 (3rd 
Edition) in CB Bulletin 101B) are also acceptable. 

Add a suffix 7) in “Conditions applicable to Table 4A, 
Parts 1 and 2”. 

In the right column of Table 4A, Part 1, add suffix 7) to 
“50” (K), corresponding to “- without T – marking” in 
the left column so as to become “50 

7)

”. 

Add 7) to Table 4A, Part 2 as follows. 

7) This value shall apply only to wiring or cords 
complying with relevant IEC standards. Others shall 
comply with Japanese requirements (refer to Japanese 
differences for the current IEC 60335-1 (3rd Edition) in 
CB Bulletin 101B). 

Considered. P 

 

Add the following in 7th paragraph. 

- for thin materials, e.g., flexible printed boards, etc., 
used inside equipment, be of FLAMMABILITY CLASS 
VTM-2 or better. 

Considered. 
 

P