Read Harman Kardon SIGNATURE 1.0 (serv.man2) User Guide / Operation Manual online
Rear Panel Connections
5
Signature 1.0
OUTPUTS
¤
L&R Balanced Stereo: Connect to the Balanced input of
the Left and Right channel audio power amplifier.
NOTE: The Balanced Stereo output can only be used if
the Power amplifier also has a Balanced input. In that
case, long runs of interconnect cables are possible
between 1.0 and the power amplifier, as any noise will be
canceled, due to the Balanced configuration.
the Power amplifier also has a Balanced input. In that
case, long runs of interconnect cables are possible
between 1.0 and the power amplifier, as any noise will be
canceled, due to the Balanced configuration.
‹
L&R stereo:
Connect to the inputs of the Left and
Right channel audio power amplifier.
›
7.1 Surround:
Connect to the inputs of the power
amplifiers used for surround sound.
fi
Record outputs:
Two pairs of RCAs carry the
identical audio signal, which is the audio output selected
through the
through the
Rec.Out
operation. Connect to the "REC IN"
input of a VCR, cassette recorder, DAT, or another audio
recording device.
recording device.
NOTE: The same signal is feed to the
L&R stereo
‹
RCAs and
7.1 Surround
›
Front L&R RCAs. This means
that the same power amplifier can be used for both Stereo
and Surround sound. However it is also possible to
connect two different power amplifiers to these outputs,
in case of bi-amping of a stereo set of loudspeakers, or in
case of dedicated surround sound power amplifiers (and
loudspeakers).
and Surround sound. However it is also possible to
connect two different power amplifiers to these outputs,
in case of bi-amping of a stereo set of loudspeakers, or in
case of dedicated surround sound power amplifiers (and
loudspeakers).
fl
IR input:
If the front panel IR sensor is blocked due to
cabinet doors or other obstructions , an external IR sensor
may be used. Connect the output of the sensor to this
jack.
may be used. Connect the output of the sensor to this
jack.
‡
IR output:
May be connected to other compatible
Harman Kardon products so that they will receive infrared
commands captured by the 1.0's remote sensor.
commands captured by the 1.0's remote sensor.
°
Trigger Output:
If a compatible Signature Series or
Harman Kardon audio power amplifier will be used with
the 1.0, connect the amplifier connection cable supplied
with the 1.0 between this jack and the "Trigger Input" of
the amplifier. The connected power amplifier will receive
a turn-on signal, as the 1.0 turns on.
the 1.0, connect the amplifier connection cable supplied
with the 1.0 between this jack and the "Trigger Input" of
the amplifier. The connected power amplifier will receive
a turn-on signal, as the 1.0 turns on.
Click on the first or last page to see other SIGNATURE 1.0 (serv.man2) service manuals if exist.