KV-32FS10 - Sony TV Service Manual (repair manual). Page 16

Coated earth ground strap

 Do not use sharp objects which may cause damage to the sur-

face of the anode-cap.

 Do not squeeze the rubber covering too hard to avoid damaging

the anode-cap. A material fitting called a shatter-hook terminal is
built into the rubber.

 Do not force turn the foot of the rubber cover. This may cause

the shatter-hook terminal to protrude and damage the rubber.

 Turn up one side of the rubber cap in

the direction indicated by arrow 

.

 When one side of the rubber cap sepa-

rates from the anode button, the anode-
cap can be removed by turning the rub-
ber cap and pulling it in the direction of
arrow 

.

 Use your thumb to pull the rubber cap

firmly in the direction indicated by
arrow 

.

WARNING: High voltage remains in the CRT even after the power is disconnected. To avoid electrical shock, discharge CRT before

attempting to remove the anode-cap. Short between anode and coated earth ground strap of CRT.

After removing the anode, short circuit the anode of the picture tube and the anode cap to either the metal chassis, CRT
shield, or carbon painted on the CRT.

High voltage remains in the CRT even
after the power is disconnected.

To avoid electrical shock, discharge CRT
before attempting to remove the anode-
cap. Short between anode and coated
earth ground strap of CRT.

Four screws

(Tapping screw 7)

 Chassis

 G/GA board

A board

 AK board

 Anode-cap

Cushion

 Deflection yoke

Neck assy

UX/UY board

 Picture tube

 C board