Read Sony KV-32FS10 Service Manual online
— 17 —
KV-32FS10/32FV15/32XBR250/34FV10/34FV15/34FV15C/34FX250C/34FV15K
34FV15T/36FS10/36FV15/36XBR250/38FX250/38FX250C/38FX250T/38FV15K
SECTION 3
SET-UP ADJUSTMENTS
The following adjustments should be made when a
complete realignment is required or a new picture
tube is installed.
complete realignment is required or a new picture
tube is installed.
These adjustments should be performed with rated
power supply voltage unless otherwise noted.
power supply voltage unless otherwise noted.
The controls and switch should be set as follows
unless otherwise noted:
unless otherwise noted:
PICTURE control ................. normal
BRIGHTNESS control ......... normal
3-1. BEAM LANDING
Preparation:
1.
Input white pattern from pattern generator.
2.
Loosen the deflection yoke mounting screw, and set
the purity control to the center as shown below:
3.
Input green pattern from pattern generator.
4.
Move the deflection yoke backward, and adjust with
the purity control so that green is in the center and
red and blue are even on both sides.
the purity control so that green is in the center and
red and blue are even on both sides.
B
R
G
Perform the adjustments in order as follows:
1. Beam Landing
2. Convergence
3. Focus
4. Screen (G2)/White Balance
2. Convergence
3. Focus
4. Screen (G2)/White Balance
Note: Test Equipment Required:
1. Color Bar Pattern Generator
2. Degausser
3. DC Power Supply
4. Digital Multimeter
5. Oscilloscope
6. CRT Analyzer
2. Degausser
3. DC Power Supply
4. Digital Multimeter
5. Oscilloscope
6. CRT Analyzer
5.
Move the deflection yoke forward, and adjust so that
the entire screen becomes green.
the entire screen becomes green.
6.
Switch over the raster signal to red and blue and
confirm the condition.
confirm the condition.
7.
When the position of the deflection yoke is determined,
tighten it with the deflection yoke mounting screw.
tighten it with the deflection yoke mounting screw.
8.
When landing at the corner is not right, adjust by using
the disk magnets.
the disk magnets.
a
b
c
d
d
a
c
Purity control
corrects this area.
Disk magnets or
rotatable disk
magnets correct
these areas(a-d).
Deflection yoke positioning
corrects these areas.
b
•
Input a white pattern signal.
•
Face the picture tube in an East or West direction to reduce the influence of geomagnetism.
NOTE: Do not use the hand degausser because it magnetizes the CRT .
Click on the first or last page to see other KV-32FS10 service manuals if exist.