DCR-PC10, DCR-PC10E - Sony Movie Service Manual (repair manual). Page 115

5-43

If the page C data is initialized, the following adjustments
must be performed again.
All RF block adjustments of “Video System Adjustments”
and “Servo System Adjustments”.

Recording the data of page: C by taking note,
recommended before initializing the page: C.

Mode

VTR stop

Adjustment Page

C

Adjustment Address

00 to 6F

If the page C data has been initialized, change the data as shown in
the following table by manual input.

The fixed values in the table are not shown because they
are different in destination. When changing the data of
page C, copy the data built in the same model.

Before changing the data, set page : 0, address: 01, data :
01.

To write in the non-volatile memory (EEPROM) after
changing the data, press the PAUSE button of the
adjustment remote commander each time to set the data.

After changing the data, set page : 0, address: 01, data :
00 and perform all RF block adjustments of “Video
System Adjustments” and “Servo System Adjustments”.

1

0

01

01

Set the data.

2

4

02

01

After setting the data, press the PAUSE button.

3

4

02

Check that the data of page: 4, address: 02 changes in the order of 01, 03, 05, 00.

4

0

01

00

Set the data. (End)

6

After Modification of Page C is performed.

08

13

19

2A

Fixed

Fixed

Fixed

26