View Sony DCR-DVD105 / DCR-DVD105E / DCR-DVD605 / DCR-DVD605E Service Manual online
mark 0 or dotted line with
mark 0 are critical for safety.
Replace only with part num-
marque 0 sont critiques pour la
Ne les remplacer que par une pièce
portant le numéro spécifié.
COMPONENTS WITH SONY PARTS WHOSE PART NUMBERS
APPEAR AS SHOWN IN THIS MANUAL OR IN SUPPLEMENTS
PUBLISHED BY SONY.
connections. Check the entire board surface for solder splashes
"pinched" or contact high-wattage resistors.
transistors, that were installed during a previous repair. Point
them out to the customer and recommend their replacement.
of deterioration. Point them out to the customer and
recommend their replacement.
free mark (LF) indicating the solder contains no lead.
(Caution: Some printed circuit boards may not come printed with
the lead free mark due to their particular size.)
• Unleaded solder melts at a temperature about 40
Ordinary soldering irons can be used but the iron tip has to be
applied to the solder joint for a slightly longer time.
Soldering irons using a temperature regulator should be set to
heated tip is applied for too long, so be careful!
ordinary solder so use caution not to let solder bridges occur such
as on IC pins, etc.
also be added to ordinary solder.
Replace only with the same or equivalent type.
CRITIQUES POUR LA SÉCURITÉ DE FONCTIONNEMENT. NE
REMPLACER CES COMPOSANTS QUE PAR DES PIÈSES SONY
DONT LES NUMÉROS SONT DONNÉS DANS CE MANUEL OU
DANS LES SUPPÉMENTS PUBLIÉS PAR SONY.
(DVD CODEC, USB I/F, DS/HI CONTROL)
(DVD DRIVE CONTROL)
include the board name.
• All capacitors are in
Be careful not to heat the minus side of tantalum
capacitor, Because it is damaged by the heat.
In such cases, the unused circuits may be indicated.
(Measuring conditions voltage and waveform)
color bar chart of pattern box. They are reference values
and reference waveforms.
(VOM of DC 10 M
(In addition to this, the necessary note is printed in each block)
Small pattern box
L = About 13 cm (PTB-1450)
In addition, ensure that the receiver is not covered with
dusts nor exposed to strong light.
Ne les remplacer que par une pièce portant le numéro
so that there PRINTED WIRING BOARD
and SCHEMATIC DIAGRAM are omitted.
and the Transistors with mark,are