Read Sony DVP-K800D Service Manual online
— 9 —
4-6.
Note on Mounting FG-43 Board
1)
Align two bosses. (See Fig.11)
2)
Fix the board securely with screws (PTPWH 2
×
5). (The sensor
will not function normally if the board floats up.)
Fig. 11
4-7.
Note on Mounting TK-47 Board
1)
Align two bosses. (See Fig.12)
2)
Align four tabs. (See Fig.12)
3)
Fix the board securely with 3 screws (BV 3
×
10). (The sensor
will not function normally if the board floats up.)
Fig.12
Screw
(PTPWH2
(PTPWH2
×
5)
FG-43 board
Two bosses
Three screws
(BV3
(BV3
× 10
)
TK-47 board
Boss
Two claws
Boss
Two claws
5.
EMERGENCY CODE INDICATION
5-1.
Users are expected to take care of the
followings by themselves – – – – “C” code
“C : 13 : XX
Clean the disc”
“C : 31 : XX
Remove and insert the disc again”
XX
00
10
20
30
40
50
61
62
63
60
70
80
90
PON ready
Stop
Trace
Pause
Drvcon Unit
Mecha Unit
Spin Up
Tracking offset
Jitter/Gain
TOC/Control Data Read
Others
Spin Down
Seek
Error Recovery
5-2.
Consult Sony Service – – – “E” code,
E : YY : ZZ
Refer to the item “5-8. Appendix” for details.
YY
01
02
03
04
06
07
10
16
21
30
31
32
33
34
35
40
41
42
60
61
62
63
EEPROM reading: NG (Check Sum has abnormality)
EEPROM writing: NG (Check Sum has abnormality)
EEPROM BUSY is displayed continuously exceeding
the specified time.
the specified time.
The pointer that shows the newest Emg History has
abnormality.
abnormality.
Communication between the HI microprocessor and
the SYS microprocessor is interrupted for a specified
time.
the SYS microprocessor is interrupted for a specified
time.
HI microprocessor cannot detect V-sync.
EEPROM CHECK NG
DSP CHECK NG
Sled driver has abnormal voltage.
Hy Det Level adjustment has abnormality.
Sled Offset Cancel adjustment has abnormality.
Focus Gain adjustment is faulty.
Tracking Offset adjustment is faulty.
Tracking Gain adjustment is faulty.
JITTER NG (only during the automatic adjustment)
Focus Servo does not lock in.
Focus Jump failed.
DSP Error Code (not used)
Mis-chucking when disc is inserted.
When disc started rotation, it did not reach the target
speed within 3 seconds.
speed within 3 seconds.
Spindle runs away/does not stop.
Lock Check (in the service mode only)
Click on the first or last page to see other DVP-K800D service manuals if exist.