Read Sony BDP-CX960 Service Manual online
BDP-CX960
25
SECTION 4
MECHANICAL ADJUSTMENTS
When trouble is found in the table stop and the detection of the
disc, or the adjustment part is taken apart, it is necessary to do the
following adjustments over again.
disc, or the adjustment part is taken apart, it is necessary to do the
following adjustments over again.
1. INTRODUCTION
1-1. Adjustment item and the order
1. POP UP MECHANISM ADJUSTMENT
2. TABLE
1-1. Adjustment item and the order
1. POP UP MECHANISM ADJUSTMENT
2. TABLE
SENSOR
ADJUSTMENT
3. DISC DETECT SENSOR ADJUSTMENT
4. SENSOR
4. SENSOR
LEVEL
ADJUSTMENT
1-2. It is necessary to do the above-mentioned 2 to 4 in
this order of 1-1.
A long screwdriver is necessary to “Table sensor adjustment”.
1-3. Wiring for adjustment
The oscilloscope and the harness are prepared.
The oscilloscope and the harness are prepared.
It is easy to work when the harness (wire with the connector) like
fi gure above is made. It is possible to substitute it by measuring the
waveforms of JL5021 and JL5022 by the short-circuit of JL5020
and JL5024 when there is no harness.
fi gure above is made. It is possible to substitute it by measuring the
waveforms of JL5021 and JL5022 by the short-circuit of JL5020
and JL5024 when there is no harness.
Adjustment/Connection location:
oscilloscope
CH1 CH2
– IMD (HF) Board (Component Side) –
(Connection with harness)
– IMD (HF) Board (Conductor Side) –
(Connection without harness)
oscilloscope
CH1 CH2
RV1001
CN5004
Sensor level adjustment
1
4
1
4
IC1001
harness
IC4002
IC2002
JL5020
JL5021 JL5022
JL5024
1-4. Entering the mechanical adjustment mode
Procedure:
1. Step 1-3 is connected and the power cord of the set is inserted.
2. The message “ADJUST MODE” is appears on the fl uorescent
Procedure:
1. Step 1-3 is connected and the power cord of the set is inserted.
2. The message “ADJUST MODE” is appears on the fl uorescent
indicator tube.
3. Press the [
N
] button, The message “TABLE_ADJUST *” is
appears on the fl uorescent indicator tube, and entering table
adjust mode.
adjust mode.
Press
the
[
X
] button, The message “DISC_ADJUST *” is ap-
pears on the fl uorescent indicator tube, and entering disc sen-
sor adjust mode.
sor adjust mode.
Press the [
x
] button, The message “ADJUST_MODE *” is
appears on the fl uorescent indicator tube, and return the adjust-
ment menu.
ment menu.
Click on the first or last page to see other BDP-CX960 service manuals if exist.