Read Sony SAL70200G2 Service Manual online
5-14
SAL70200G2 (2.8/70-200 G SSM Ⅱ) (70-200mm F2.8 G SSM II)
5-8. HALF COMPLETION ADJUSTMENT/INSPECTION
1. Preparations
(1) When performing except MR adjustment/check
Connect a jumper wire on the CL-033 board as shown in the figure or leave the switch base plate block connected.
Connect a jumper wire on the CL-033 board as shown in the figure or leave the switch base plate block connected.
It connects.
Fig.
5-8-1
(2) When performing MR adjustment/check
1) Disassemble parts to the state shown below.
1) Disassemble parts to the state shown below.
Fig.
5-8-2
2) Temporarily install the mount block.
CL-033 Board
CL-032 Board
CL-034 Board
Fig.
5-8-3
3) Leave the flexible cable of the MR sensor and the magnetic scale connected.
Fig.
5-8-4
(3) Half completion JIG II and inspection-target lens installation procedure
Install the M-BOX JIG to the mount section.
Note:
Install the M-BOX JIG to the mount section.
Note:
Lay down the lens.
At this time, put a cushion or the like under the mount section to protect the lens from being damaged.
When performing except MR adjustment/check
M-BOX JIG
Cushion
Finished Inspection
JIG
JIG
Fig.
5-8-5
When performing MR adjustment/check
M-BOX JIG
Cushion
Finished Inspection
JIG
JIG
Fig.
5-8-6
Click on the first or last page to see other SAL70200G2 service manuals if exist.