Read Sony SAL70200G Service Manual online
HELP
SAL70200G (2.8/70-200 G) (70-200mm F2.8 G)
HELP20
Adhesive bond (B-10): J-6082-612-A
1.
Fix the brush holder to the front holding tube block with two screws and washers tentatively.
Note:
Be careful not to bend the leads of brush.
2.
Set the focus to the infinity end.
3.
Adjust the brush holder so that the curved portion (contact with the flexible board) of A encoder brush comes to the circle portion
(Part R) of DV encoder flexible PC board and tighten firmly two screws.
4.
After performing the [5-7. Focus Brush (A Encoder Brush) Position Adjustment], apply the adhesive bond (B-10) to the head of
screw at two locations.
Brush Holder
DV Encoder Flexible
PC Board
PC Board
Part R of
A encoder brush
A encoder brush
A Encoder Brush
Brush Holder
Screws Several pieces of washer
(The number of washer used differs
depending on the result of adjustment.)
depending on the result of adjustment.)
A Encoder Brush
Set the focus to the infinity
end position
end position
Apply the
adhesive bond
(B-10)
adhesive bond
(B-10)
Click on the first or last page to see other SAL70200G service manuals if exist.