Read Sony SAL70200G Service Manual online
HELP
SAL70200G (2.8/70-200 G) (70-200mm F2.8 G)
HELP13
Adhesive bond (B-10): J-6082-612-A
1.
Overlay the aperture blade unit clockwise.
2.
Open the aperture operate plate unit and install the aperture hold ring so that the aperture blade unit protrudes a little from the hole.
3.
Install nine screws tentatively.
4.
After performing [5-2-2. Aperture Diameter Adjustment], tighten firmly nine screws and apply the adhesive bond (B-10) as shown
below.
5.
Apply the adhesive bond (B-10) to the portion A (head of screw) at three locations (at an interval of every two screws).
6.
Apply the adhesive bond (B-10) portion B (protruded portion at the tip of screw) (9 locations).
Apply the adhesive bond (B-10)
Portion A (head of screw) (3 locations)
(at an interval of every two screws)
Portion A (head of screw) (3 locations)
(at an interval of every two screws)
Apply the adhesive bond (B-10)
Portion B (protraded at the tip of screw)
(9 locations)
Portion B (protraded at the tip of screw)
(9 locations)
Overlay the aperture
blade unit clockwise
blade unit clockwise
Install the aperture hold ring.
(The aparture blade unit
protrudes a little from the hole)
(The aparture blade unit
protrudes a little from the hole)
Set the aperture operate
plate unit to the open state
plate unit to the open state
Aperture Hold Ring
Screw
(9 pieces)
(9 pieces)
Click on the first or last page to see other SAL70200G service manuals if exist.