Read Sony SAL50F14Z Service Manual online
2-3
HELP
The following shows notes for assembling and grease applying positions.
SAL50F14Z (Planar 1,4/50 ZA) (Planar T*50mm F1.4 ZA SSM)
HELP 01
Bond (B-10) : J-6082-612-A
1. Cut the tip of new brush with nippers.
2. Install the brush and fix it with one screw.
3. After adjusting the brush position, apply adhesive bond (B-10) to the head of screw.
2. Install the brush and fix it with one screw.
3. After adjusting the brush position, apply adhesive bond (B-10) to the head of screw.
Brush
Cut with nippers.
Screw (M1.6)
Tightening torque:
Tightening torque:
0.06
± 0.01 N.m
Apply adhesive
bond (B-10)
bond (B-10)
HELP 02
Bond (B-10) : J-6082-612-A
1. Install the two washers and the GMR flexible board, and tighten two screws.
Note:
When installing the GMR flexible board, tighten two screws to the specified tightening torque paying attention not to deform it.
2. Apply adhesive bond (B-10) to the head of screws.
Screws (B1.7 x 3)
Tightening torque:
Tightening torque:
0.12
± 0.01 N.m
GMR Flexible Board
Washers
Apply adhesive
bond (B-10)
bond (B-10)
HELP 03
Bond (B-10) : J-6082-612-A
1. Install the sensor ring block assy and three washers, and tighten three screws.
2. Apply bond (B-10) to fix the screws, washers, and the sensor ring block assy.
2. Apply bond (B-10) to fix the screws, washers, and the sensor ring block assy.
Washer
Sensor Ring Block ASSY
Apply adhesive
bond (B-10)
bond (B-10)
Click on the first or last page to see other SAL50F14Z service manuals if exist.