Read Sony SAL30M28 Service Manual online
SAL30M28 (DT 2.8/30 MACRO SAM) (DT 30mm F2.8 Macro SAM)
2-6
HELP10
1. Set the main unit assembly to the infinity end and insert counterclockwise the helicoids male as far as it goes.
2. Align the round mark on the filter screw frame with the concave at the side of the round mark on the outer tube.
3. Install the lens unit assy to the main unit assy, aligning the driving wheel pin with the cut portion (working part of driving
2. Align the round mark on the filter screw frame with the concave at the side of the round mark on the outer tube.
3. Install the lens unit assy to the main unit assy, aligning the driving wheel pin with the cut portion (working part of driving
wheel pin).
Note 1:
Insert three projections of front group (rear) group assy in three grooves of vertical group cylinder.
Note 2:
Insert three projections of outer tube in three grooves of focus ring assy.
4. Tighten with three screws.
Note:
Install screws in the center of oblong holes of filter screw frame.
Screw
Oblong hole of
Filter Screw Frame
Filter Screw Frame
Round mark
(Outer Tube)
(Outer Tube)
Concave
Round mark
(Filter Screw Frame)
(Filter Screw Frame)
Projection
(Outer Tube)
(Outer Tube)
Projection
(Front Group (Rear) Group Assy)
(Front Group (Rear) Group Assy)
Helicoid Male
Lens Unit Assy
Main Unit Assy
Driving wheel pin
Groove
(Focus Ring Assy)
(Focus Ring Assy)
Cut portion
(Working part of driving wheel pin)
(Working part of driving wheel pin)
Vartical
groove
Cylinder
groove
Cylinder
Vertical groove
HELP11
Grease (G-116): J-6082-628-A
1. Apply the grease (G-116) to the indicated portion of filter screw frame.
2. Install the filter screw frame to the front group (rear) group assy and fix it with three screws.
2. Install the filter screw frame to the front group (rear) group assy and fix it with three screws.
Note:
Align the bulge of front group (rear) group assy so that the bulge comes inscription (Reverse side) of filter screw frame.
Front Group
(Rear) Group Assy
(Rear) Group Assy
Filter Screw Frame
Bulge
Apply the Grease (G-116)
Inscription
(Reverse side)
(Reverse side)
3. Assemble the filter screw frame into the outer tube with rotating counterclockwise the filter screw frame.
Note 1:
Insert, aligning the round mark on the outer tube with the round mark on the filter screw frame.
Note 2:
Rotate clockwise the filter screw frame until it clicks and engage the filter screw frame with the outer tube.
Filter Scerw Frame
Filter Scerw Frame
Note 2
Helicoid
Outer Tube
Outer Tube
Round mark
Round mark
Click on the first or last page to see other SAL30M28 service manuals if exist.