SAL30M28 - Sony Digital Camera Service Manual (repair manual). Page 7

SAL30M28 (DT 2.8/30 MACRO SAM) (DT 30mm F2.8 Macro SAM)

2-4

Grease (G-36): J-6082-667-A

1.  Apply the grease (G-36) to the main spring sliding surface of mount.

  Do not spread the grease to the mount inner side.

  Do not apply the grease to the 1mm from edge of wall.

Mount

Do not spread the grease 
to the mount inner side

Cross section (Coating portion)

1mm
(Edge of wall)

Do not apply

Apply the grease (G-36)
(Main spring sliding surface)

Grease (G-36)

1.  Install the G06 frame assy, fix it with three screws.

  Install it so that round mark of G06 frame assy (object side) is located on the index side.

Round mark

Distance 
index

G06 Frame Assy

G06 Frame Assy (Object side)

How to remove the switch panel block (Scar prevention)

1.  Remove three screws fixing the rear mirror assy tube.
2.  Set the switch panel block to  AF .
3.  Hold down the middle lens barrel assy and pull up the rear mirror assy tube slightly to the direction of the mount until the in-

dicated hole of rear mirror assy tube is seen.

4.  Insert tweezers or a narrow tip stick in the hole of rear mirror assy tube and peel the switch panel block by pushing it from the 

inside with the tweezers or the narrow tip stick.

Rear Mirror Assy Tube

Direction of the Mount

Middle Lens Barrel Assy

Narrow tip stick

Hole

Switch Panel Block

Note on the switch panel block installation

1.  Set the select switch of DC motor (geared) to AF.
2.  Set the knob of switch panel block to AF.
3.  Peel the released paper off the switch panel block and install the switch panel block.

Select switch of
DC Motor (Geared)

Switch Panel Block

Knob

AF Side

MF Side