Read Sony SAL28F28 Service Manual online
HELP
SAL28F28 (2.8/28) (28mm F2.8)
HELP04
Adhesive bond (LOCTITE 460) (Note)
Note:
Use adhesive bond (LOCTITE 460) or an equivalent article.
Do not use what becomes white after drying like quick-drying glue.
Anti-diffusion agent (A-20): J-6082-611-A
Adhesive bond (B-40):
J-6082-614-A
1.
Apply the adhesive bond ((LOCTITE 460) to the back side of the mount guide mark, and attach it to the outer barrel ring.
2.
Apply the anti-diffusion agent (A-20) to the instruction portions of the outer barrel ring.
3.
Attach the outer barrel ring and outer barrel hold plate as shown in the figure. Apply the adhesive bond (B-40) to portion screwed of
the three screws and tighten them as shown in the figure.
HELP05
1.
Attach the main flexible unit to the rear light shield barrel tube with two screws as shown in the figure.
2.
Affix the main flexible unit to flexible set tape as shown in the figure.
3.
Bend the main flexible unit to inside of rear light shield barrel tube, fix with the flexible set tape in the arrow direction.
Note:
When handling the main flexible unit, take care the static electricity.
Apply the adhesive bond(B-40)(3 areas)
Outer Barrel Ring
Apply the anti-diffusion agant(A-20)
(All circumference)
(All circumference)
Outer Barrel Hold Plate
Apply the adhesive bond (LOCTITE460)
(Back side)
(Back side)
Rear Light Shield Barrel Tube
Ground Spring
Main Flexible Unit
Two Screws
Flexible Set Tape
Rear Light Shield Barrel Tube
Main Flexible Unit
Click on the first or last page to see other SAL28F28 service manuals if exist.