Read Sony SAL135F28 Service Manual online
HELP
SAL135F28 (STF 2.8(T4.5)/135) (135mm F2.8 [T4.5] STF)
HELP08
Adhesive bond (B-10): J-6082-612-A
1.
Attach the chip holder with the two screws as shown in the figure.
2.
Cut off one of six terminals of the brush and makes it to five as shown in the figure.
3.
Set the focus ring to the infinity stop position.
4.
Tighten the brush with the two screws as shown in the figure.
5.
Apply the adhesive bond (B-10) to the two instruction portions as shown in the figure.
6.
Loosen the two screws tightened in step 1.
7.
Adjust the position of the chip holder so that the five terminals of the brush are surely contact with the main flexible unit, and also
adjust the position to locate the second terminal from the top within the range of infinity, and tighten the two screws loosened in step
6.
8.
Perform the “4-6-2. Focus Brush Position Adjustment/Pattern Check”.
9.
After adjustment, apply the adhesive bond (B-10) to the two instruction portions as shown in the figure.
Screws
Chip Holder
Brush
Cut off the Bottom Terminal
Range of infinity
Apply the Adhesive Bond (B-10) (Two areas)
After adjustment, Apply the Adhesive Bond (B-10) (Two areas)
Screws
Main Flexible Unit
Brush
Click on the first or last page to see other SAL135F28 service manuals if exist.