Read Sony SAL135F18Z Service Manual online
HELP
SAL135F18Z (Sonnar 1.8/135 ZA) (Sonnar T
*
135mm F1.8 ZA)
HELP19
1.
After removing the tilt adjustment washers, they should reinstall the replaced positions.
Note:
After replacing the lens block 4, install the three tilt adjustment washers D (0.1mm) as shown in figure.
2.
Install the 4 lens block, aligning it with positioning pins at three locations of length grove barrel assy. Then, tighten three screws to
fix the 4 lens block.
HELP20
Adhesive bond (B-10): J-6082-612-A
Special driver:
J-6082-654-A
1.
Affix the focus scale to meet the length grove barrel assy (vertical, horizontal).
Note:
• Confirm that the focus scale is not floated.
• Confirm that the surface of focus scale is clean.
2.
Expose both ends of focus scale by peeling off the protection tape so that screws can be tightened.
3.
Fix the focus scale with two screws. (Use the special driver: J-6082-654-A)
4.
Apply the adhesive bond (B-10) to the heads of screws.
Length Grove Barrel Assy
Positioning Pins
Positioning Pins
4 Lens Block
Screws
Positionaing Pins
Tilt Adjustment Washer D
Tilt Adjustment Washer D
Focus Scale
Pasted standard
Horizontal
Pasted standard
Vertical
Screws
(Apply the adhesive bond (B-10))
(Apply the adhesive bond (B-10))
Length Grove Barrel Assy
Click on the first or last page to see other SAL135F18Z service manuals if exist.