DSC-RX100M2 (serv.man2) - Sony Digital Camera Service Manual (repair manual). Page 14

DSC-RX100M2_L2

1-11

下図は当機種と本体の形状が異なります。

Ornamental Ring A

は，位置決めのボスがあるため，

左右にひねらず矢印方向に取り外してください。

Barrier Tapes

5. Disengage the four claws and remove the Barrier Assy.

1. Fit the four claws while inserting the Barrier Lever into the hole and attach the Barrier Assy.

2. Peel off the release papers of the Barrier Tapes.
3. Install the Ornamental Ring A and press it lightly.

1. Turn on the power switch and extend the lens (TELE end).
2. Detach the battery.
3. Apply alcohol to two gaps A of the Ornamental Ring A with tweezers or a fine-tipped stick as shown below.
4. Detach the Ornamental Ring A.

Boss

Barrier Assy

Claws

Claws

Barrier Assy

Claws

Claws

A

Solvent

Tweezers

Ornamental Ring A

Ornamental Ring A

Hole

Barrier
Lever

Barrier Tapes

Barrier Assy

Do not turn the Ornamental Ring A because 
there is a Positioning Boss. Detach the 
Ornamental Ring A in the arrow direction.

Note: As for the figure below, this model and the shape

of the main body are different.

Hook

Solders

FG Retainer

Sensors

LF-155 Flexible Board

Zoom Gear Assy (1560)

Removal
1. Remove the screw.

Zoom Gear Assy (1560)

Screw

2. Remove the Zoom Gear Assy (1560).

3. Remove the solders at two locations on the LF-155 Flexible Board and remove the FG Retainer.
4. Remove the two Sensors to detach the Zoom Gear Assy (1560).