Read Sony DSC-KW1 / DSC-KW11 Service Manual online
4-13
DSC-KW1/KW11
4-3-8. TP Adjustment
Update the firmware for TP control while checking the sensitivity of the TP.
TP Adjustment order is as follows.
1) Check that the camera is on the adjustment mode.
1) Check that the camera is on the adjustment mode.
Note:
• For the setting procedure of the adjustment mode, refer to “4-1-5. Setting the Adjustment Mode” (Page 4-3).
• Confirm that there is nothing to touch the surface of TP. (nothing including protection sheet or etc.)
• Confirm that there is nothing to touch the surface of TP. (nothing including protection sheet or etc.)
(Adjust it again if something touches the surface of TP by mistake.)
• Adjust it after the battery cover was closed.
2) Touch the Up, Down, Right or Left key to change selected item. Choose “UPDATE_TUPFW”, touch the Set key, select “OK”, and touch
the Set key to start. (Fig. 4-3-21)
X.XXXX
A0E6V3000033
Index : 01
TEST
X
BACKUP
RESTORE
UPDATE_TUPFW
UPDATE_TUPFW
OK
NO
Fig.
4-3-21
Note:
• Waiting time from start is about three minutes 30 seconds. (This means from start to end of update is about three minutes 30seconds.)
• When starting the update, message screen [Battery Low!!] is still appeared, replace a battery that capacity is enough.
• When starting the update, message screen [Battery Low!!] is still appeared, replace a battery that capacity is enough.
Battery Low!!
Please power off by power key
Fig.
4-3-22
Click on the first or last page to see other DSC-KW1 / DSC-KW11 service manuals if exist.