Read Sony WX-800UI Service Manual online
WX-800UI
4
REPLACING THE LITHIUM BATTERY OF THE REMOTE
COMMANDER (E, Indian and Australian models only)
COMMANDER (E, Indian and Australian models only)
Under normal conditions, the battery will last
approximately 1 year. (The service life may be
shorter, depending on the conditions of use.)
When the battery becomes weak, the range of the
remote commander becomes shorter.
approximately 1 year. (The service life may be
shorter, depending on the conditions of use.)
When the battery becomes weak, the range of the
remote commander becomes shorter.
CAUTION
Danger of explosion if battery is incorrectly
replaced. Replaced only with the same or
equivalent type.
replaced. Replaced only with the same or
equivalent type.
Notes on the lithium battery
ˎ Keep the lithium battery out of the reach of children.
Should the battery be swallowed, immediately
consult a doctor.
consult a doctor.
ˎ Wipe the battery with a dry cloth to ensure a good
contact.
+ side up
ˎ Be sure to observe the correct polarity when installing
the battery.
ˎ Do not hold the battery with metallic tweezers,
otherwise a short-circuit may occur.
WARNING
Battery may explode if mistreated.
Do not recharge, disassemble, or dispose of in
fire.
Do not recharge, disassemble, or dispose of in
fire.
DESTINATION ABBREVIATIONS
The following abbreviations for model destinations are used in this
service manual.
The following abbreviations for model destinations are used in this
service manual.
• Abbreviations
AUS :
AUS :
Australian
model
IND
: Indian model
RU
: Russian model
NOTE OF REPLACING THE COMPLETE MAIN BOARD
OR SERIAL FLASH (IC502)
When the complete MAIN board or serial fl ash (IC502) is re-
placed, the destination setting is necessary.
OR SERIAL FLASH (IC502)
When the complete MAIN board or serial fl ash (IC502) is re-
placed, the destination setting is necessary.
1. Destination Setting
Set destination according to the procedure below.
Set destination according to the procedure below.
1-1. Setting the Destination Code
1. In the state of source off (the clock is displayed), enter the test
1. In the state of source off (the clock is displayed), enter the test
mode by pressing the buttons in order of the [ 4] t [5] t
[PAUSE 6] (press only the [PAUSE 6] button for two seconds).
(Displayed characters/values in the following fi gure are ex-
ample)
ample)
Clock display
2. In the state in which the system controller version is displayed
on the liquid crystal display (refer to following fi gure), enter
the destination setting mode by pressing the buttons in order of
the [
the destination setting mode by pressing the buttons in order of
the [
M>
SEEK+] t [SEEK–
.m
] t [PUSH ENTER/
MENU].
(Displayed characters/values in the following fi gure are ex-
ample)
ample)
System controller version
3. Input the alphanumeric character of 12 digits of “F XXXXXX”
displayed on the liquid crystal display, and execute the destina-
tion setting.
tion setting.
(Displayed characters/values in the following fi gure are ex-
ample)
ample)
Note: Refer to following “1-3. Entering the Destination Code” on page 5
for operation method.
Destination code
12 digits
OP0
OP1
OP2
OP3
OP4
OP5
– Continued on next page –
Click on the first or last page to see other WX-800UI service manuals if exist.