Read Sony MDX-F5800 Service Manual online
7
MDX-F5800
How to detach and attach the
front panel (
front panel (
7
)
Before installing the unit, detach the front
panel.
panel.
7
-A To detach
Before detaching the front panel, be sure to
press (OFF). Press (OPEN), then slide the front
panel to the right side, and pull out the left side.
press (OFF). Press (OPEN), then slide the front
panel to the right side, and pull out the left side.
7
-B To attach
Place the hole A in the front panel onto the
spindle B on the unit as illustrated, then push
the left side in.
spindle B on the unit as illustrated, then push
the left side in.
Warning when installing in a car
without ACC (accessory)
position on the ignition key
switch
without ACC (accessory)
position on the ignition key
switch
After turning off the ignition, be sure to
press and hold
press and hold
(OFF)
on the unit until the
display disappears.
Otherwise, the display does not turn off and this
causes battery drain.
causes battery drain.
RESET button
When the installation and connections are
completed, be sure to press the RESET button
with a ball-point pen, etc., after detaching the
front panel.
completed, be sure to press the RESET button
with a ball-point pen, etc., after detaching the
front panel.
Precautions
•Choose the installation location carefully so
that the unit will not interfere with normal
driving operations.
driving operations.
•Avoid installing the unit in areas subject to
dust, dirt, excessive vibration, or high
temperatures, such as in direct sunlight or
near heater ducts.
temperatures, such as in direct sunlight or
near heater ducts.
•Use only the supplied mounting hardware for
a safe and secure installation.
Mounting angle adjustment
Adjust the mounting angle to less than 45°.
Removing the protection collar
and the bracket (
and the bracket (
4
)
Before installing the unit, remove the
protection collar 3 and the bracket 1 from
the unit.
protection collar 3 and the bracket 1 from
the unit.
1
Remove the protection collar 3.
1 Engage the release keys 5 together with
1 Engage the release keys 5 together with
the protection collar 3.
2 Pull out the release keys 5 to remove the
protection collar 3.
2
Remove the bracket 1.
1 Insert both release keys 5 together
1 Insert both release keys 5 together
between the unit and the bracket 1 until
they click.
they click.
2 Pull down the bracket 1, then pull up
the unit to separate.
Mounting example (
5
)
Installation in the dashboard
Notes
• Bend these claws outward for a tight fit, if
• Bend these claws outward for a tight fit, if
necessary (5-2).
• Make sure that the 4 catches on the protection
collar 3 are properly engaged in the slots of the
unit (5-3).
unit (5-3).
Mounting the unit in a
Japanese car (
Japanese car (
6
)
You may not be able to install this unit in some
makes of Japanese cars. In such a case, consult
your Sony dealer.
makes of Japanese cars. In such a case, consult
your Sony dealer.
Note
To prevent malfunction, install only with the
supplied screws 2.
To prevent malfunction, install only with the
supplied screws 2.
Click on the first or last page to see other MDX-F5800 service manuals if exist.