Read Sony HCD-ESX6 / HCD-ESX8 / HCD-ESX9 Service Manual online
HCD-ESX6/ESX8/ESX9
13
2-8. SERVICE OPTICAL DEVICE, WIRE (FLAT TYPE)
Note 1 : Before disconnecting the wire (fl at type) (24 core) of optical pick-up block, solder the short-land.
Under the guide
Under the guide
(Fold area)
(Fold area)
,QVWDOODWLRQRIZLUHIODWW\SHFRUHDQGZLUHIODWW\SHFRUH
Note: This illustration sees the loading assy (MB) from bottom side.
1 wire (flat type) (24 core)
2 Through the hole
3 Through the hole
4
terminal face
loading assy (MB)
7 wire (flat type)
(24
core)
6 holder, FFC
5 three claws
5 two claws
0 wire (flat type)
(5
core)
8 core, ferrite
9 tape
(
8 four insulator screws
7 connector
qa insulator
6 belt
3 Insert the thin
wire (clip etc.).
5 tray
qs service,
optical
device
qa insulator
qa insulator
qg
ql wire (flat type)
(24
core)
qj core, ferrite
1
six claws
4
9
0
2 chuck holder assy (MB)
2 Solder the short-land.
qf wire (flat type)
(5
core)
– Bottom view –
loading assy (MB)
qd loading base
assy
qk holder, FFC
qh tape
Note 2: When assembling the optical pick-up block,
remove the solder of short-land after
connecting the wire (flat type) (24 core).
(E93)
(E93)
Click on the first or last page to see other HCD-ESX6 / HCD-ESX8 / HCD-ESX9 service manuals if exist.