VC-S2000 (serv.man18). Operation Manual - Part 4 - Basic operation - Sharp VCR User Guide / Operation Manual. Page 7

 

9

 

Press  [

/

]  to select SAT NO. Turn to the table at the end of this manual. Look for 

the make of  your satellite receiver and use the

 

 to enter the first 

code number listed. For example number 8 should be entered 0 0 8. Your satellite 
should now change to preset channel 12.

 

If your satellite receiver has changed to preset channel 12,  press 

 

 to confirm the VCR 

will automatically install both satellite and terrestrial channels. (This may take a few 
minutes).

 

The VCR will attempt to copy the TV preset list (NexTView compatible TV’s only). During 
the copying process the display will show the TV presets that are being copied. If the VCR 
is unable to copy the TV preset list the terrestrial and satellite channels will be 
automatically installed. (Auto install may take a few minutes.)  
On completion the MOVE menu will appear showing the preset channel order. By 
pressing the 

 

 button, the VCR will change to a blue background. This may 

help you see which channels your VCR has tuned in. Press

 

to exit. The correct 

Time and Date should be displayed on your TV screen for approximately 

 seconds. If the 

clock is not automatically set, the clock screen will appear, refer to 

. 

If you wish to customise the channel order refer to 

.

If you replace your satellite receiver, you will need to follow the complete auto-
installation procedure to tune your VCR to the satellite receiver. This is because your 
new satellite receiver will not over-write the previous satellite channels in your VCR.

• If your satellite receiver has not changed to preset channel 12 enter the next code 

number on the list. Continue until the receiver shows preset channel 12, then continue 
from point 10.

• If your satellite receiver is not listed at the end of this manual or after entering all the 

numbers listed for your receiver, the satellite receiver preset channel has still not changed 
to 12, enter  

, and look to see if the satellite receiver has changed to preset channel 

12. If it has, continue from point 10. If not, press 

 to select

 and re-check. Continue 

until your receiver changes to preset 12, then continue from point 10.

• If there is still no response from your satellite receiver, try adjusting its position to improve 

the Infra Red VCR to satellite receiver reception.

• Auto-installation will stop when the satellite receiver reaches preset channel 99, or when 

all the 99 VCR preset channels have been used.

• The VCR will place all found terrestrial channels starting at preset 1, then all satellite 

channels from the first available preset channel after the terrestrial channels.

If you connect a satellite receiver to the VCR for the first time, after auto-installation, see 

.

TINS-3894 ENGLISH.book  Page 9  Wednesday, September 6, 2000  11:53 AM