Read Sharp VC-S2000 (serv.man18) User Guide / Operation Manual online
8
If problems persist contact the SHARP Helpline on tel: 08705-274277 (office hours)
or www.sharp.co.uk/support
INSTALLLING YOUR VCR
AUTO INSTALLATION
6.
Ensure your AERIAL/SCART cable is connected to your VCR and then press
SET
to confirm
7.
SAT CONTROL will be highlighted.
•
If you
do
have a satellite receiver connected to
the VCR continue from point
8
.
•
If you
do not
have a satellite receiver
connected to the VCR leave SAT CONTROL
set to OFF and press
SET
.
The VCR will attempt to copy the TV preset list (NexTView compatible TV’s only). During the
copying process the display will show the TV presets that are being copied. If the VCR is
unable to copy the TV preset list the terrestrial channels will be automatically installed. (Auto
install may take a few minutes.)
On completion the MOVE menu will appear showing the preset channel order. By pressing the
Mode OSD
button, the VCR will change to a blue background. This may help you see which
channels your VCR has tuned in. Press
MENU
to exit. The correct Time and Date should be
displayed on your TV screen for approximately
2
seconds. If the clock is not automatically set,
the clock screen will appear, refer to
MANUALLY SETTING THE CLOCK
.
If you wish to customise the channel order refer to
MANUALLY SORTING CHANNELS
.
All the programmes should now be correctly tuned in and the clock
set.
set.
Points 8-13. (Satellite/Cable Box Control only)
8.
Select Channel 1 on your satellite receiver.
9.
Press [
/
], to set SAT CONTROL to ON.
10.
Press [
/
], to select INPUT (as shown
opposite). L2 will be highlighted.
If the VCR is not connected to the satellite
receiver as shown previously:
receiver as shown previously:
i.
Your satellite receiver should be connected to
the Antenna (RF in on the back of the VCR)
select RF IN using [
/
] You will need to
tune the VCR into the Satellite receiver.
ii.
Press [
/
] to select CHANNEL on the On Screen Display.
iii.
Press [
]. The current channel will be displayed as a background to the on-screen
display. If this is not a satellite channel press [
] again. Continue until you see a satellite
channel. By pressing the
Mode OSD
button, the VCR will change to a blue background.
This may help you see which channel your VCR has tuned in.
S A T
R E C E I V E R
S A T CON T RO L ON
O F F
7
9
S A T
R E C E I V E R
S A T CON T RO L
ON
O F F
➔
I N P U T
R F I N
L 2
S A T NO .
0 0 1
P L E A S E CONN E C T - - - - -
S A T
L 2
V CR
- - - - - - - - - - -
: S E L EC T
: CHANGE
S E T
: E N T E R ME NU : E X I T
TINS-3894 ENGLISH.book Page 8 Wednesday, September 6, 2000 11:53 AM
Click on the first or last page to see other VC-S2000 (serv.man18) service manuals if exist.