Read Sharp TU-X1E (serv.man8) Service Manual online
TU-X1E/RU
7 – 2
14
IC2003
RH-IXC331WJQZ
MONITOR
MICON
M16C/64CEC
MICON
M16C/64CEC
This IC is a 16-bit monitor microcomputer which carries M16C/60 series
CPU core . In this IC, detection of the STB key unit, control of the
POWER signal, control of the FAN, control of the 5V, INV control, etc. are
performed. Moreover, detection of the error about the power supply in
MAIN board and power supply management of the MAIN part are per-
formed.
CPU core . In this IC, detection of the STB key unit, control of the
POWER signal, control of the FAN, control of the 5V, INV control, etc. are
performed. Moreover, detection of the error about the power supply in
MAIN board and power supply management of the MAIN part are per-
formed.
7/19
15
IC2006
VHIBR24L08M-1Y
8K E2PROM
This IC is 8K bit serial E2PROM of 1024 word *8K bit configuration.
This IC saves the data of a portion with which IC2003 (MONITOR-
MICON) is processing.
This IC saves the data of a portion with which IC2003 (MONITOR-
MICON) is processing.
7/19
16
IC2007/08
VHILCX125FT-1Y
BUS BUFFER
This IC is 3 state buffer of the low voltage drive.
If 3 State control input (OE#) is made into "H", an output will be in a float-
ing (high impedance) state.
If 3 State control input (OE#) is made into "H", an output will be in a float-
ing (high impedance) state.
7/19
17
IC9103
RH-
iXC121WJQZQ
iXC121WJQZQ
CPLD
This IC performs the CPLD (Complex Programmable Logic Device). A
MUTE signal, a RESET signal, I/O processing, HDMI detection process-
ing, etc. are controlled by this IC.
MUTE signal, a RESET signal, I/O processing, HDMI detection process-
ing, etc. are controlled by this IC.
8/19
18
IC4405
VHILCX245FT-1Y
BUS TRAN-
CEIVER
CEIVER
This IC is a low voltage (3.3V) CMOS 8bit bidirectional transceiver. When
setting the transmission direction change input DIR to “H”, the A bus is
switched to input and the B bus is changed to output; if the DIR is set to
“L”, the B bus is switched to input and the A bus is changed to output.
When setting the enable input OE to “H”, both A and B buses enter the
high impedance state. In this equipment, it used to switch bus of the data
from CI-CARD.
setting the transmission direction change input DIR to “H”, the A bus is
switched to input and the B bus is changed to output; if the DIR is set to
“L”, the B bus is switched to input and the A bus is changed to output.
When setting the enable input OE to “H”, both A and B buses enter the
high impedance state. In this equipment, it used to switch bus of the data
from CI-CARD.
9/19
19
IC4404/08
VHILCX573FT-1Y
D_TYPE_LATC
H
H
This IC is CMOS 8 bit D type latch of the low voltage drive.
This IC is composed by the independent latch in 8 bits controlled by latch
enable signal (LE) and output enable (OE).
If an enabling input (OE#) is made into "H", an output will be in a floating
(high impedance) state.
This IC is composed by the independent latch in 8 bits controlled by latch
enable signal (LE) and output enable (OE).
If an enabling input (OE#) is made into "H", an output will be in a floating
(high impedance) state.
9/19
20
IC4409
VHILCX244FT-1Y
BUS BUFFER
This IC is CMOS 8 bit bus buffer of the low voltage drive.
3 state control input is every 4 bits, is common, and either dual 4 bit com-
position or the single 8 bit composition can be used.
If an enabling input (OE#) is made into "H", an output will be in a floating
(high impedance) state.
3 state control input is every 4 bits, is common, and either dual 4 bit com-
position or the single 8 bit composition can be used.
If an enabling input (OE#) is made into "H", an output will be in a floating
(high impedance) state.
9/19
21
IC7001
RH-
IXC595WJQZQ
IXC595WJQZQ
CI-Interface
This is a control IC for PCMCIA cards. This controls information on IC
cards inserted into the PCMCIA card slot (SC9101) or information on soft-
ware version upgrade cards saved on flash memories to transfer the data
to CPUs and memories.
cards inserted into the PCMCIA card slot (SC9101) or information on soft-
ware version upgrade cards saved on flash memories to transfer the data
to CPUs and memories.
11/19
22
IC2403
VHIIM3221EIP
RS-232C-
RECEI/DRIV
RECEI/DRIV
The MAX3221E is a single driver, single receiver RS-232 solution operat-
ing from a single Vcc supply. The RS-232 pins provide IEC G1000-4-2
ESD Protection. The device meets the requirements of TIA/EIA-232-F and
provides the electrical interface between an asynchronous communication
controller and the serial-port connector.
ing from a single Vcc supply. The RS-232 pins provide IEC G1000-4-2
ESD Protection. The device meets the requirements of TIA/EIA-232-F and
provides the electrical interface between an asynchronous communication
controller and the serial-port connector.
12/19
23
IC2402
VHILCX157FT-1Y
MULTIPLEXER
TC74LCX157FT is a CMOS multiplexer of a low-voltage (3.3V) drive.
In this model, It is used for a RS-232C signal changing whether it is in PC
or a VIDEO signal state.
In this model, It is used for a RS-232C signal changing whether it is in PC
or a VIDEO signal state.
12/19
24
IC1803
/1804
/1804
VHIL6726A++-1Y
PWM_CONTRO
LLER
LLER
L6726A is a single-phase step-down controller with integrated high-cur-
rent drivers that provides complete control logic, protections and refer-
ence voltage to realize in an easy and simple way general DC-DC
converters by using a compact SO-8 package. In this model, D1.1V, and
D1.0V which are used within MAIN board are generated.
rent drivers that provides complete control logic, protections and refer-
ence voltage to realize in an easy and simple way general DC-DC
converters by using a compact SO-8 package. In this model, D1.1V, and
D1.0V which are used within MAIN board are generated.
14/19
25
IC1807/05/08
VHILV5805M+-1Y
1CH-SW-REG
This IC is a 1CH step down switching regulator.
In this model, D3.3V, D5V and D1.8V which are used within MAIN board
are generated.
In this model, D3.3V, D5V and D1.8V which are used within MAIN board
are generated.
14/19
26
IC1806
VHIMP2367DE-1Y
STEPDOWN-
CONV
CONV
This IC is a monolithic non-synchronous step-down regulator. In this
model, The 7.4V drive power supply for driving FAN is generated.
model, The 7.4V drive power supply for driving FAN is generated.
14/19
27
IC1801
VHIBH33FB1G-1Y BU3.3V-REG
BHOOFB1WHFV/G series are high-performance LDO CMOS regulators
with 150mA output that yields
with 150mA output that yields
±1% of high-accuracy output voltage. In this
model, BU3.3V which is used within MAIN board are generated.
14/19
28
IC1910
VHILTC1154+-1Y
5V-REG
It is power supply IC for supplying the object 5V for the wireless transmis-
sion units of an option. It has short circuit detection and a thermal shut-
down function. .
sion units of an option. It has short circuit detection and a thermal shut-
down function. .
14/19
29
IC5001
RH-IXC446WJZZ
H264-
DECODER
DECODER
This IC is digital-signal-processing IC at the time of satellite broadcasting
reception.
Decoding processing, *** processing, etc. are performed by this IC.
reception.
Decoding processing, *** processing, etc. are performed by this IC.
15/19
30
IC5201/02
RH-IXC187WJQZ
512M-SDRAM
DDR400
DDR400
This IC is 512Mb DDR2 SDRAM and VDD voltage is 2.5V
± 0.2V.
In this model, This IC operates as a memory of IC5001 (H264-
DECODER)
DECODER)
16/19
NO
REF NO
Name
Part Code
Description
Draw-
ing No
Click on the first or last page to see other TU-X1E (serv.man8) service manuals if exist.