LC-32GA6E (serv.man5) - Sharp TV User Guide / Operation Manual. Page 19

Press the RADIO button on the remote control unit to listen
to FM radio. To use this function, you must first insert the
antenna cable into the corresponding FM antenna connector.

E

You can make adjustments for FM radio broadcasting by
using RADIO on the remote control unit.

Press RADIO to display the RADIO menu screen.

Press a/b to select the preset radio channel.

Press c/d to adjust the volume.

Press END to exit the RADIO menu screen.

E

You can search automatically for and store stations.

Press RADIO to display the RADIO menu screen.

Press  OK, and then “WARNING: RADIO STATIONS
WILL BE ERASED” is displayed.

Press OK to start station search.

• The unit searches for radio programmes and stores and

sorts all programmes found (according to set defaults).

• The search may take several minutes.

Press END to exit the RADIO menu screen.

• To delete, edit or change the order of radio programmes,

refer to “EDIT” on page 8 and 16.

E

You can search manually for and store new stations.

Press RADIO to display the RADIO menu screen.

Press Red to search manually for a radio programme.

• Input the two digits (0-9) to search for a new radio

programme, and then “RADIO TUNING” is displayed.

Press  a/b to select “FREQUENCY” or “SCAN” to
search for stations:

1 Press a/b to select “FREQUENCY”.
2 Press c/d to search for a frequency or enter the five

digits (0–9) of the desired frequency.

3 Press OK to store the station.

1 Press a/b to select “SCAN”.
2 Press c/d to search for the preceding or subsequent

radio programme.
• Search stops as soon as a station is found.
• Press c/d again until the desired station is found.

3 Press OK to store the station.

You can adjust the “PICTURE” and “SOUND” modes to your
preference setting when your TV receives HD signal image.

Press  b on the remote control unit to display the
“EXT. SOURCES MENU” screen.

Press a/b to select “EXT4” or “EXT5”, and then press
OK.

For PICTURE setting:
Press MENU or Red to display PICTURE setting.

1 Press a/b to select your desired PICTURE item.

(CONTRAST/BRIGHTNESS/COLOUR/SHARPNESS/
HDMI SETUP*/DVI SETUP VIA HDMI*)

* HDMI SETUP or DVI SETUP VIA HDMI are available

only for EXT 5. Press a/b to select the desired item,
and then press OK. (See page 17.)

2 Press c/d to adjust the item to your desired position.
3 Press END to exit.

For SOUND setting:
Press Green to display SOUND setting.

1 Press a/b to select your desired SOUND item.

(VOLUME/BALANCE/LOUDNESS/DYNAMIC BASS/
MODE)

2 Press a/b/c/d to adjust your desired position or select

your desired item.

3 Press END to exit.

LC-26/32/37GA6E(E)_c

05.6.29, 7:50 AM

19