XG-V10XE (serv.man9). Page 20-59 - Sharp Projector Service Manual (repair manual). Page 13

1. Feed the 10-step signal to

the G (Y) input terminal on
the BNC socket.

2. Select the following group

and subjects.
Group : DVD
Subject : R1-GAIN

B1-GAIN

3. Connect the oscilloscope to

pin (1) (for R) of P1001 and
pin (3) (for G) of P1001.

4. Similarly connect the oscil-

loscope to the following for
the B color.
Pin (5) of P1001 for B
Pin (3) of P1001 for G

»

Select R1-GAIN. Adjust the setting so that the R
signal amplitude and the G signal amplitude be
the same.

»

Do the same for the B color.

1. Feed the NTSC

monoscope pattern signal
to the G (Y) input terminal
on the BNC socket.

2. Select the following group

and subjects.
Group : DVD
Subject : R1-BLK

B1-BLK

»

Make sure the white balance is the same as on
the monitor screen.

»

If not, adjust the setting so that the white balance
be the same as on the monitor screen, using the
set's control switch or the remote controller's
button.

1. Feed the 100% color bar

signal of the 480I compo-
nent signal to the Y, Pb and
Pr input terminals on the
BNC socket.

2. Select the following group

and subject.
Group : DVD
Subject : COLOR

3. Connect the oscilloscope to

pin (1) of P801.

»

Using the set’s control switch or the remote
controller’s button, adjust the setting so that the
amplitude between the 100% white and red levels
be 0.00 ± 0.02 Vp-p.

100% White Red

Make sure the lamp optical
axis has been already ad-
justed.
1. Feed the XGA, 60-Hz gray-

only signal.

2. Check for uneven color

spot on the screen.

3. Select the following group

and subject.
Group : NOKO
Subject : NOKO-G
Choose the subject NOKO-
R for the R color.

»

When the green color is found not uneven, turn off
the saw-tooth wave correction with S4201.

»

Select NOKO-G and adjust the setting to minimize
the color unevenness at right and left on the
screen.

For the R color, use S4202 to turn on or off the wave
correction.