XG-V10XE (serv.man9). Page 20-59 - Sharp Projector Service Manual (repair manual). Page 11

1. Feed the split color bar sig-

nal.

2. Select the following group

and subject.
Group : VIDEO1
Subject : AGC
Make sure there are some
bit dropouts on the screen.

»

Using the set’s control switch or the remote
controller’s button, adjust the setting so that the
100% white signal has some bit-less.

1. Feed the split color bar sig-

nal. Select the following
group and subject.
Group : VIDEO1
Subject : TINT

2. Connect the oscilloscope to

pin (4) of P801.

»

Using the set's control switch or the remote
controller's button, adjust the setting so that the –
(B–Y) waveform runs straight downhill.

1. Feed the split color bar sig-

nal.

2. Select the following group

and subject.
Group : VIDEO1
Subject : N-COLOR

3. Connect the oscilloscope to

pin (1) of P801.

»

Using the set’s control switch or the remote
controller’s button, adjust the setting so that the
amplitude between the 100% white and red levels
be 0.20 ± 0.02 Vp-p.

100% White Red

1. Feed the PAL color bar sig-

nal.

2. Select the following group

and subject.
Group : VIDEO1
Subject : P-COLOR

3. Connect the oscilloscope to

pin (1) of P801.

»

Using the set's control switch or the remote
controller’s button, adjust the setting so that the
amplitude between the 100% white and red levels
be 0.32 ± 0.02 Vp-p.

1. Feed the SECAM color bar

signal.

2. Select the following group

and subject.
Group : VIDEO1
Subject : S-COLOR

3. Connect the oscilloscope to

pin (1) of P801.

»

Using the set's control switch or the remote
controller’s button, adjust the setting so that the
amplitude between the 100% white and red levels
be 0.50 ± 0.02 Vp-p.

100% White Red

100% White Red