Read Sharp XG-PH70X (serv.man10) User Guide / Operation Manual online
XG-PH70X/XG-PH70X-N
1 – 14
Regarding the Lamp
4
Remove the lamp unit.
Loosen the securing screws (two for
each lamp) from the lamp unit. Hold the
lamp unit by the handle and pull it in the
direction of the arrow. At this time, keep
the lamp unit horizontal and do not tilt it.
each lamp) from the lamp unit. Hold the
lamp unit by the handle and pull it in the
direction of the arrow. At this time, keep
the lamp unit horizontal and do not tilt it.
5
Insert the new lamp unit.
Press the lamp unit firmly into the lamp
unit compartment. Fasten the securing
screws.
Be sure that AN-PH7LP1 and AN-
PH7LP2 are respective type.
unit compartment. Fasten the securing
screws.
Be sure that AN-PH7LP1 and AN-
PH7LP2 are respective type.
6
Replace the lamp unit cover.
Align the lamp unit cover and slide it to
close. Then tighten the user service
screw to secure the lamp unit cover.
close. Then tighten the user service
screw to secure the lamp unit cover.
Info
If the lamp unit and lamp unit cover are not
correctly installed, the power will not turn
on, even if the power cord is connected to
the projector.
correctly installed, the power will not turn
on, even if the power cord is connected to
the projector.
Securing screws
Handle
Compartment for
AN-PH7LP1
AN-PH7LP1
Compartment for
AN-PH7LP2
AN-PH7LP2
AN-PH7LP2
AN-PH7LP1
For Lamp 1
For Lamp 2
User service screw
Click on the first or last page to see other XG-PH70X (serv.man10) service manuals if exist.