Read Sharp XG-PH70X (serv.man10) User Guide / Operation Manual online
XG-PH70X/XG-PH70X-N
1 – 13
Optional
accessories
Lamp unit 1
AN-PH7LP1
AN-PH7LP1
the Lamp Unit
Removing and Installing
Info
Ensure the lamp unit is removed using the
handle. Ensure the glass surface of the
lamp unit or the inside of the projector are
not touched.
To avoid injury to yourself and damage to
the lamp, make sure you carefully follow
the steps below.
Do not loosen other screws except for the
lamp unit cover and lamp unit.
(Only the silver screws are loosened.)
handle. Ensure the glass surface of the
lamp unit or the inside of the projector are
not touched.
To avoid injury to yourself and damage to
the lamp, make sure you carefully follow
the steps below.
Do not loosen other screws except for the
lamp unit cover and lamp unit.
(Only the silver screws are loosened.)
1
Press
on the projector or
on the remote control to put
the projector into standby mode.
Wait until the cooling fan stops.
Warning!
Do not remove the lamp unit from the
projector right after use. The lamp and
parts around the lamp will be very hot
and may cause burn or injury.
projector right after use. The lamp and
parts around the lamp will be very hot
and may cause burn or injury.
2
Disconnect the power cord.
Unplug the power cord from the AC
socket.
Leave the lamp until it has fully cooled
down (about 1 hour).
socket.
Leave the lamp until it has fully cooled
down (about 1 hour).
3
Remove the lamp unit cover.
Loosen the user service screw (
) that
secures the lamp unit cover. Remove the
lamp unit cover (
lamp unit cover (
).
STANDBY button
1
1
2
2
User service screw
Lamp unit 2
AN-PH7LP2
AN-PH7LP2
Click on the first or last page to see other XG-PH70X (serv.man10) service manuals if exist.