Read Sharp XG-PH50X Handy Guide online
Lamp Replacement Procedure
Version 1.1
Issue 04/2006
Issue 04/2006
11
SHARP ELECTRONICS (UK) LTD
PROJECTOR TECHNICAL SUPPORT
TECHNICAL SERVICES GROUP
Removing and Installing the Lamp Unit
Note
•
Ensure the lamp unit is removed by using the handle. Ensure the glass surface of the
lamp unit or inside the projector are not touched.
lamp unit or inside the projector are not touched.
•
To avoid injury to yourself and damage to the lamp, be sure to carefully follow the steps
below.
below.
•
Do not loosen other screws except for the lamp unit cover and lamp unit. (Only the silver
screws are loosened).
screws are loosened).
•
Please refer to the installation manual included with the lamp unit.
1.
Press “STANDBY” on the projector to turn off
the power.
the power.
•
Wait until the cooling fan stops.
Warning!
•
Do not remove the lamp unit from the projector right
after use. The lamp will be very hot and may cause burn
or injury.
after use. The lamp will be very hot and may cause burn
or injury.
2.
Disconnect the power cord.
•
Unplug the power cord from the AC socket.
•
Leave the lamp until it has fully cooled down (about 1
hour).
hour).
Click on the first or last page to see other XG-PH50X service manuals if exist.