XG-P20XE (serv.man20). Section 4 Basic Operation - Sharp Projector User Guide / Operation Manual. Page 8

• Used to automatically adjust a computer image.
• Auto Sync adjustment can be made manually by pressing AUTO SYNC, or automatically by setting

“Auto Sync” to “Normal” or “High Speed” in the projector’s GUI menu. See page 

 for the procedure

details.

You can adjust this setting by accessing the “Button Assign” list on your GyroRemote. Choose popup list “4/5” and
press Function Assign (2). (See page 

.)

• Synchronized adjustment is not automatically performed.
• Press AUTO SYNC to perform manual adjustment.

• Synchronized adjustment is automatically performed the

same as the “High Speed” setting.

• Adjustment using the “Normal” setting takes longer to

perform than using the “High Speed” setting, but it is more
accurate.

• The sync adjustment is automatically made each time the

projector is turned on while connected to a computer or
the input selection is changed.

• The Auto Sync adjustment setting previously made is

cleared when the projector’s setting is changed.

• Automatic adjustments can be made by pressing AUTO SYNC.
• When performing AUTO SYNC in Off or High Speed mode, if you press AUTO SYNC once, then press it again within one

minute, AUTO SYNC will be executed in Normal mode.

• Auto Sync adjustment may take some time to complete, depending on the image of the computer connected to the projector.
• When the optimum image cannot be achieved with Auto Sync adjustment, use manual adjustments. (See page 

.)

Normally, an image is not superimposed during Auto Sync adjustment. You can, however, choose to
superimpose a background image during Auto Sync adjustment.