Read Sharp MX-RBX1 (serv.man8) Service Manual online
MX-FNX2/AR-PN1/MX-RBX1 DISASSEMBLY AND ASSEMBLY 6 – 10
5)
Remove the screw [8]; then, while freeing the claw [9], detach
the paper guide (rear) [10].
the paper guide (rear) [10].
6)
Remove the two stop rings [11]; then, move the two bushings
[12] to the inside.
[12] to the inside.
7)
Remove the four screws [13]; then, lift the stack delivery roller
assembly (lower) [14] to detach.
assembly (lower) [14] to detach.
8)
Remove the stack delivery roller (lower) [15] and the two deliv-
ery belts [16].
ery belts [16].
NOTE: Be sure to mount them so that the edges [17] of the claws
of the delivery belts are flush.
C. PCBs
(1) Finisher Controller PCB
1)
Remove the rear cover. (See A.(3).)
2)
Disconnect the 17 connectors [1], and remove the screw [2].
3)
Free the PCB retainer [3], and detach the finisher controller
PCB [4].
PCB [4].
(2) Slide Home Position PCB
1)
Open the front door, and turn the tab [2] on the stapler slide in
the direction of the arrow to slide the stapler to the frontmost
point.
the direction of the arrow to slide the stapler to the frontmost
point.
2)
Remove the stapler unit. (See B.(1).)
3)
Place the stapler unit [3] as shown.
4)
Remove the two screws [4], and detach the guide [5].
5)
Turn the tab [2] on the stapler side in the direction of the arrow
so that that the fixing screw [7] of the slide home position PCB
[6] is in view through the round hole.
so that that the fixing screw [7] of the slide home position PCB
[6] is in view through the round hole.
6)
Remove the fixing screw [7].
[8]
[10]
[9]
[11]
[11]
[12]
[12]
[14]
[13]
[13]
[16]
[15]
[17]
[2]
[1]
[1]
[4]
[1]
[3]
1
2
[4]
[5]
[4]
[3]
[2]
[6]
[7]
Click on the first or last page to see other MX-RBX1 (serv.man8) service manuals if exist.