Read Sharp MX-PE10 FIERY (serv.man2) Service Manual online
I
NSTALLING
H
ARDWARE
21
T
O
CONNECT
TO
THE
NETWORK
1 Make sure that the Fiery Server is powered off.
2 Make sure that the network cable is connected to the customer site network.
3 Connect the network cable to the upper RJ-45 network port on the back of the Fiery Server.
The Fiery Server provides twisted pair connectivity to an Ethernet network. When the
network cable is connected, the Ethernet interface automatically detects the speed of the
network environment. Depending on your network speed, the following unshielded twisted
pair (UTP) network cables are supported:
network cable is connected, the Ethernet interface automatically detects the speed of the
network environment. Depending on your network speed, the following unshielded twisted
pair (UTP) network cables are supported:
• 10BaseT: Category 3 or higher
• 100BaseTX: Category 5 or higher (4-pair/8-wire, short-length)
• 1000BaseT: Category 5e or higher (4-pair/8-wire, short-length)
After power on, the network administrator should perform Network Setup, verify the network
connection, verify that the Fiery Server appears in the list of printers, and then print a few test
documents from a networked computer that will use the Fiery Server. For more information,
see Configuration and Setup, which is part of the user documentation set.
connection, verify that the Fiery Server appears in the list of printers, and then print a few test
documents from a networked computer that will use the Fiery Server. For more information,
see Configuration and Setup, which is part of the user documentation set.
N
OTE
:
The network cable at the customer site and the straight-through Ethernet cable
included with the MFP look similar, but are not interchangeable. Make sure that you connect
the network cable to the upper RJ-45 port on the Fiery Server connector panel (see
the network cable to the upper RJ-45 port on the Fiery Server connector panel (see
page 29
).
Configuring a static IP address for the Fiery Server
If the customer requires the Fiery Server to be configured with a static IP address (for
example, in a non-DHCP network environment), obtain a valid static IP address from the
network administrator and configure the Fiery Server.
example, in a non-DHCP network environment), obtain a valid static IP address from the
network administrator and configure the Fiery Server.
Click on the first or last page to see other MX-PE10 FIERY (serv.man2) service manuals if exist.