Read Sharp MX-PE10 FIERY (serv.man2) Service Manual online
I
NSTALLING
H
ARDWARE
15
I
NSTALLING
H
ARDWARE
Installation problems are easier to avoid and diagnose if you proceed from the component to
the system level and verify functionality at each stage. The following procedure should take
place:
the system level and verify functionality at each stage. The following procedure should take
place:
• Preparing for hardware installation or service procedures (see
page 15
)
• Installation sequence (see
page 15
)
• Checking the customer site (see
page 16
)
• Unpacking the Fiery Server (see
page 18
)
• Installing the Fiery Server and connecting it to the MFP and the network (see
page 19
)
• Completing the installation (see
page 22
)
– Print a Test Page and a Configuration page.
– If the Fiery Server requires a static IP address (for example, in a non-DHCP network
environment), work with the network administrator to configure it
as described on
as described on
page 21
.
– Remind the site administrator to install the current user software on networked
computers that print to the Fiery Server (see Printing and Utilities, which are part of the
user documentation set.
user documentation set.
Installation sequence
Because the Fiery Server is a node on the customer’s computer network, make sure that you
coordinate your scheduled installation with the network administrator at the customer site.
For Network Setup information, refer the network administrator to Configuration and Setup,
which is part of the user documentation set.
coordinate your scheduled installation with the network administrator at the customer site.
For Network Setup information, refer the network administrator to Configuration and Setup,
which is part of the user documentation set.
N
OTE
:
You can change the default language that is preinstalled at the factory using the
Configure tool available through Command WorkStation and WebTools. Start Configure,
choose Server > General > Choose Server Language, and then click Apply. It takes up to three
minutes to change languages.
choose Server > General > Choose Server Language, and then click Apply. It takes up to three
minutes to change languages.
1 Check installation requirements and verify site conditions.
If possible, obtain verification that the network is operational (see
page 16
).
2 Unpack the Fiery Server (see
page 18
).
3 Connect the monitor, keyboard, mouse, and furniture to the Fiery Server if applicable.
For more information on setting up the furniture, see Furniture, 19-inch Monitor, Keyboard,
and Mouse for PRO Series.
and Mouse for PRO Series.
Click on the first or last page to see other MX-PE10 FIERY (serv.man2) service manuals if exist.