Read Sharp MX-PE10 FIERY (serv.man2) Service Manual online
I
NTRODUCTION
13
• Unless you are the network administrator, never assign an IP address in Fiery Server Network
Setup.
In a DHCP environment, the system assigns the IP address automatically. In a non-DHCP
environment, enter only the IP address that has been assigned by the network administrator.
Only the network administrator should assign an IP address to a network device. Assigning
the Fiery Server an incorrect IP address may cause unpredictable errors on any or all devices
connected to the network.
environment, enter only the IP address that has been assigned by the network administrator.
Only the network administrator should assign an IP address to a network device. Assigning
the Fiery Server an incorrect IP address may cause unpredictable errors on any or all devices
connected to the network.
Creating an electrostatic discharge (ESD) safe environment
• Follow standard ESD precautions while working on the internal components of the Fiery
Server.
Static is always a concern when servicing electronic devices. It is highly unlikely that the area
around the MFP and the Fiery Server is static-free. Carpeting, leather-soled shoes, synthetic
clothing fibers, silks, and plastics may generate a static charge of more than 10,000 volts.
Static discharge is capable of destroying the circuits etched in silicon microchips, or
dramatically shortening their life span. By observing standard precautions, you may avoid
extra service calls and save the cost of a new board.
around the MFP and the Fiery Server is static-free. Carpeting, leather-soled shoes, synthetic
clothing fibers, silks, and plastics may generate a static charge of more than 10,000 volts.
Static discharge is capable of destroying the circuits etched in silicon microchips, or
dramatically shortening their life span. By observing standard precautions, you may avoid
extra service calls and save the cost of a new board.
When possible, work on a ground-connected antistatic mat. Wear an antistatic grounding
strap, grounded at the same place as the antistatic mat. If that is not possible, do the
following:
strap, grounded at the same place as the antistatic mat. If that is not possible, do the
following:
• Attach a grounding strap to your wrist. Attach the other end to a good ground.
• When you unpack the Fiery Server from the carton for the first time, touch a metal area of
the MFP to discharge the static on your body.
• Before you remove any of the Fiery Server panels and handle internal components, touch a
metal part of the Fiery Server.
• Leave new electronic components inside their antistatic bags until you are ready to install
them. When you remove components from an antistatic bag, place them on a grounded
antistatic surface, component-side up.
antistatic surface, component-side up.
• When you remove an electronic component, place it in an antistatic bag immediately.
Do not walk across a carpet or vinyl floor while carrying an unprotected board.
• During service to the motherboard, avoid using excessive force and always place the
motherboard on a grounded, non-metallic, antistatic surface. Never allow any metal to
touch the solder contacts on the underside of the motherboard, especially beneath the
battery socket. Improper handling can short circuit and permanently damage the
motherboard.
touch the solder contacts on the underside of the motherboard, especially beneath the
battery socket. Improper handling can short circuit and permanently damage the
motherboard.
• Handle printed circuit boards by their opposing edges only and avoid touching the contacts
on the edge of the board.
Click on the first or last page to see other MX-PE10 FIERY (serv.man2) service manuals if exist.