MX-M364N, MX-565N (serv.man4). Service Manual (Revised January 2016). - Sharp Copying Equipment Service Manual (repair manual). Page 68

MX-M565N  ADJUSTMENTS AND SETTINGS  4 – 38

(Auto gray balance adjustment by the serviceman)

NO

YES

Start

Execute ADJ10C(1) Copy gray balance and density adjustment 

(automatic

adjustment

).

Enter the SIM46-24 mode, and select A4 (11" x 8.5") paper. 

(Automatic selection)

Press [EXECUTE] key. (The adjustment pattern is printed.)

Set the adjustment pattern on the document table. press 
[EXECUTE] key.
(The adjustment pattern is scanned, and the adjustment is 
automatically performed to print the check pattern.) 

Check the printed check pattern for any streaks or unclear copy. (*2)

Press [OK] key, and the initial setting of the halftone image correction
is automatically performed. (*1) 

Cancel SIM46-24

Check the gray balance and density adjustment result.

Use the test chart (UKOG-0326FCZZ/UKOG-0326FC11) to make a 

copy in the Text/Printed Photo mode, and check the copy gray bal-

ance and density.

Use SIM46-16 to print the gray balance check pattern, and check the 

patch gray balance and density in the process gray. (If the gray bal-

ance is slightly shifted to Magenta, it is properly adjusted.)

Check that the initial setting of the halftone image correction was properly 
performed. (*1)

Execute the initial setting of the halftone image correction.

(SIM44-21)

Execute the halftone image correction. (SIM44-26)

Use the test chart (UKOG-0326FCZZ/UKOG-0326FC11) 

to make a copy in the Text/Printed Photo mode, and check

the gray balance and density.

Are the gray balance and den-

sity at the satisfactory level?

End

*1:
If the initial setting of the halftone image 
correction is not properly made, satisfactory 
gray balance and density cannot be 
obtained. In this case, check the print engine 
for any problems. 
*2:
If there is any streak or unclear copy on the 
printed check pattern, check the print 
engine for any problems.