MX-M350N, MX-M350U, MX-M450N, MX-M450U (serv.man21). Administrator Settings Guide - Sharp Copying Equipment User Guide / Operation Manual. Page 15

These settings are set when this product is used as a
network printer. 
After you complete the setting for one setting, you must
exit the administrator settings, turn off the main switch,
wait briefly, and then turn on the main switch again
before any other settings can be set. The setting that
was set will be effective after the power is turned on.
The following items can be configured in the "Network
settings".

● IPv4 setting
● IPv6 setting
● Enable TCP/IP
● Enable NetWare
● Enable EtherTalk
● Enable NetBEUI
● Reset the NIC
● Tandem setting
● PING command

When using this product in a network that uses the TCP/IP
protocol (IPv4), use this setting to set the IP address (IP
address, IP subnet mask, and IP gateway) of this product.
The setting is set to ENABLE DHCP by factory default
setting, which obtains the IP address setting automatically.
When using this product on a TCP/IP network, be sure to
turn on the "Enable TCP/IP" setting below.

When using this product in a network that uses the
TCP/IP protocol (IPv6), use this setting to set the IP
address (enable IPv6, DHCPv6, IP address, prefix
length, and default gateway) of this product. By factory
default, the IPv6 setting is disabled. When using this
product on a TCP/IP network, be sure to turn on the
"Enable TCP/IP" setting below.
In an IPv6 environment, the machine can use LPD or
IPP protocol.

When using this product in a network that uses the
TCP/IP protocol, set this setting. Also set the IP
address using the setting "IP address setting" above.
Default setting: Enable

When using this product in a network that uses the
NetWare protocol, set this setting.
Default setting: Enable

When using this product in a network that uses the
EtherTalk protocol, set this setting.
Default setting: Enable

When using this product in a network that uses the
EtherTalk protocol, set this setting.
Default setting: Enable

This setting is used to reset all setting items of NIC
(Network Interface Card) of this product to the factory
default settings.

● About stopped jobs

Printing of received faxes and Internet-Faxes and
transmission of stored fax jobs will automatically
resume after the machine restarts.
For jobs other than the above (copy jobs, print
jobs, document filing print jobs, etc.), the job
information is not retained and thus the stopped
job must be executed again manually (for
example, the original for a copy job must be
placed again and the copy operation repeated).

● Operation after optimization starts

Until optimization finishes (or the [CANCEL] key is
touched to cancel optimization),
• The operation panel cannot be used, with the

exception of the [CANCEL] key.

• Operation from the Web page is not possible.
• Faxes and Internet-Faxes cannot be received.
• Print jobs will not be accepted.
• The power will not turn off even if the power

switch is switched off.

• Auto power shut-off mode will not activate even

if the set time elapses. (Preheat mode will
activate.)

For setting and modification of "Network settings",
be sure to consult with the network administrator.

If DHCP is used, the IP address assigned to the
machine may be changed automatically on occasion.
If this happens, printing will not be possible.

If DHCP is used, the IP address assigned to the
machine may be changed automatically on occasion.
If this happens, printing will not be possible.

If any of the [NETWORK SETTINGS] were changed
prior to execution of this setting, you must turn off the
power switch after exiting the administrator setting,
wait briefly, and then turn on the power switch to
make the factory default settings take effect.

JupiterII_Admin_ex.book  13 ページ  ２００６年１２月４日　月曜日　午後１時３６分