MX-LC13 (serv.man15). IMPROVEMENTS FOR INSTALLING MX-LC13 N - Sharp Copying Equipment Technical Bulletin (repair manual). Page 10

MX-M1204  MX-LC13 (LARGE CAPACITY TRAYS)  8 – 8

2) If the image shifts to the rear side, lift up the rear side adjuster

in order to correct the paper transport position as a figure
below. 

b. Mechanical Adjustment2
1) Pull out the cassette.

Press the lock button on the front cabinet and lower the paper
feed base tray to the paper supply position. Pull out the tray.
* In case the machine is turned off, If it is necessary to release
the lock manually, push the shaft at the bottom of the front cab-
inet and lower the paper feed base tray to the paper supply
position and pull out the tray. 

When shifting the line of printing from the center of the paper in
the direction A of arrow as shown below:

2) Loosen the blue screws of the rear regulation plate, and move

the plate with referring the carved marks by the dimension
shifted in the direction A (R side), and tighten the blue screws.

3)

Set a sheet of paper on the paper feed base tray and loosen
the blue screws of the front regulation plate.
Move the front regulation plate to the direction A (R side) with
pushing paper to the front regulation plate.

4)

Set the front regulation plate to make gap between the rear
sideplate and paper and tighten the blue screws of the fron
regulation plate.

NOTE: Avoid bending paper with too much closing the regula-

tion plates.

NOTE: When shifting the line of printing from the center of the

paper to rear side, move the front regulation plate to
adjust it.

1)

Run Sim50-10 using the keypad on the main unit.

2)

This screen allows you to configure the print off-center adjust-
ment value for each paper feed tray.

3)

On the touch panel, press DOWN key to select "H: 50:
MAINLCT1."

4)

Enter the desired adjustment value through the numeric key-
pad. (This value, which defaults to 50, can be adjusted within
the range of 1 to 99)
-  Reducing the adjustment value by 1 causes the main scan/

print position to shift by 0.1mm toward the rear.

-  Increasing the adjustment value by 1 causes the main scan/

print position to shift by 0.1mm toward the front.

5)

After entering the adjustment value, press the [EXECUTE] key
on the touch panel to start printing and save the setting.

6)

Check that the adjustment pattern image is printed in the cor-
rect position.
Measure the dimensions of the void areas on the front and rear
frame sides of the adjustment pattern image, and make sure
that the following conditions are met:

If the above condition is not met, do the following:

5HDU

%OXH6FUHZV

5HJXODWLRQ3ODWH

)URQW

3DSHU

3XVKSDSHUWRWKHIURQW
VLGHSODWH

MM

3DSHU

$

%

3ULQWHGVXUIDFH

3DSHUGHOLYHU\
GLUHFWLRQ

,IWKHGLPHQVLRQRI%LVELJ͆2IIFHQWHU͇
VKLIWGLUHFWLRQLVUHDUGLUHFWLRQ

,IWKHGLPHQVLRQRI$LVELJ͆2IIFHQWHU͇
VKLIWGLUHFWLRQLVIURQWGLUHFWLRQ

5HDU6LGH

)URQW6LGH

$%
PP0HFKDQLFDODGMXVWPHQWPP0HFKDQLFDODGMXVWPHQW