MX-LC13 (serv.man15). IMPROVEMENTS FOR INSTALLING MX-LC13 N - Sharp Copying Equipment Technical Bulletin (repair manual). Page 57

MX-7500N  MX-LC13 (LARGE CAPACITY TRAYS)  9 – 14

5) Check that the adjustment pattern image is printed in the cor-

rect position.
Measure the dimensions of the void areas on the front and rear
frame sides of the adjustment pattern image, and make sure
that the following conditions are met:

No adjustment is needed if A-B=+/-2.0 mm.
If the above condition is not met, do the following:

6) Change the adjustment value. (Enter the adjustment value and

press the [OK] key.)
Changing the adjustment value by 1 shifts the position by
approximately 0.1 mm. 
Repeat steps 4) to 6) until the condition shown in step 6) is sat-
isfied. 

7) After you have completed the adjustment, exit from Simulation

mode by pressing the [CA] key.
MEMO：For details of the adjustment and checking proce-
dures, refer to the "[5] ADJUSTMENTS AND SETTINGS" on
the Service Manual.

NOTE: When installing this machine in a place of low atmospheric

pressure, check and conform to the adjustment contents in
the MX-LC13 Service Manual.

NOTE: Before installation, be sure to turn both the operation and

main power switches off and disconnect the power plug
from the power outlet. Make double sure that the data lamp
on the operation panel does not light up or blink when per-
forming installation.

1)

Draw out the second tray from the unit.
Push the button of the bottom side of the unit to unlock the
tray, and then slowly pull out the tray until it stops.

2)

Remove 3 screws from the tray.

3)

For 19 inch size paper, remove the step screw.

4)

Slowly insert the tray to the original position.

!

"

3ULQWHGVXUIDFH

3DSHUGHOLYHU\
GLUHFWLRQ

,IWKHGLPHQVLRQRI%LVELJ͆2IIFHQWHU͇
VKLIWGLUHFWLRQLVUHDUGLUHFWLRQ

,IWKHGLPHQVLRQRI$LVELJ͆2IIFHQWHU͇
VKLIWGLUHFWLRQLVIURQWGLUHFWLRQ

5HDU6LGH

)URQW6LGH