MX-LC13 (serv.man15). IMPROVEMENTS FOR INSTALLING MX-LC13 N - Sharp Copying Equipment Technical Bulletin (repair manual). Page 56

MX-7500N  MX-LC13 (LARGE CAPACITY TRAYS)  9 – 13

In the case of diagonal feed 2
Loosen the 2 blue screws (1) on the front regulation plate.
Referring to the degree of diagonal feed, move the regulation
plate in the counterclockwize direction and fix the blue screw.

Loosen the 2 blue screws (2) on the rear regulation plate.
To make parallel with the front regulation plate, move the rear
regulation plate in the counterclockwize direction and fix the
screws.

NOTE: When fixing the rear regulation plate, not to fix it more

closely against the paper.
(The target of the gap between the edge of paper and the
rear regulation plate is about 1.0mm)

NOTE: After completion of the adjustment, check that the front reg-

ulation plate and the rear regulation plate are in parallel to
each other.

In order to avoid the unstable installation, underlay the adjustment
bolt with the adjuster and fix LC13 to the floor.

NOTE: Fix the right side adjuster not to change the height level of

LC13 largely.

NOTE: If the fixation of LC13 is unstable, it might be moved when

insert the tray to the unit.

1)

If there’s some gap between cabinets or door adjustment is neces-
sary, adjust the height adjustment.
1)

Install the adjuster (Packed items No.3) and adjuste the height
of LC13 (4 places)

2)

Adjust height in order to make the gap evenly of  each cabinet
as the figure below.

3)

Adjust height in order to make the height and the gap evenly of
each cabinet as the figure below.

Though the off-center adjustment has been made by CIS function,
if the fine adjustment is necessary, perform the following adjust-
ment.
1)

Run Sim50-10 using the keypad on the main unit.

2)

On the touch panel, press [DOWN] Key to select "H: 50:
MAINLCT1."

3)

Enter the desired adjustment value through the numeric key-
pad. (This value, which defaults to 50, can be adjusted within
the range of 1 to 99)

4)

After entering the adjustment value, press the [EXECUTE] key
on the touch panel to start printing and save the setting.

-    Reducing the adjustment value by 1 causes the main scan/

print position to shift by 0.1mm toward the rear.

-    Increasing the adjustment value by 1 causes the main scan/

print position to shift by 0.1mm toward the front.

)URQW

3DSHU

5HDU

5HJXODWLRQ3ODWH

TopPage

: ‘14/Jan