Read Sharp MX-GBX1 Service Manual online
5
2. INSTALLATION AND SET-UP OF SMARTPUNCH
2.1 RECOMMENDATIONS
AND PRE-REQUISITES
•
If installing the SmartPunch downstream from a Booklet Maker a SmartPunch cover kit is required.
2.2 UNPACKING
•
Inspect the outside of the package for shipping damage. If there is evidence of shipping damage,
contact the shipping carrier immediately.
contact the shipping carrier immediately.
•
Remove the punch from its shipping carton. It is recommended that three people remove the
punch unit from the carton; one lifting at the castors and two lifting at the top cover. DO NOT lift
using the front door panel.
punch unit from the carton; one lifting at the castors and two lifting at the top cover. DO NOT lift
using the front door panel.
•
Retain the smaller accessory box; it contains parts required for correct installation of the
SmartPunch.
SmartPunch.
•
Inspect for any concealed damage to the unit. If there is evidence of concealed shipping damage,
contact the shipping carrier immediately.
contact the shipping carrier immediately.
•
Remove all shipping tape from doors and levers.
2.3 SMARTPUNCH
INSTALLATIONS
(MX-M850) (MX-M950) (MX-M1100)
2.3.1 MX-FNX Finisher Preparation
Only the cables below are required to attach the SmartPunch to this type of finisher.
MX-FNX Finisher to SmartPunch Cable
Set up instructions for Sharp series Document number 771014AWA1
Only the cables below are required to attach the SmartPunch to this type of finisher.
MX-FNX Finisher to SmartPunch Cable
Set up instructions for Sharp series Document number 771014AWA1
P/N GBC7708935000
Click on the first or last page to see other MX-GBX1 service manuals if exist.