Read Sharp MX-FNX6 Service Manual online
MX-FNX6 REPLACEMENT AND ADJUSTMENT 4 – 7
6)
Lift the adjustment screw slightly upward, and let is fall by its
own weight.
own weight.
7)
Set the center binding staple unit, and close the front door.
8)
Set A3 paper (any paper other than black background) on the
DSPF.
DSPF.
9)
Set the staple position to the center binding.
(Do not select the image edit.)
(Do not select the image edit.)
10) Press the copy start button, and perform center binding of one
set only.
11) Draw an arrow mark on the paper discharged to the center
binding tray.
12) Align the folded sides as shown below, and fold paper so that
the arrow comes inside.
* Shift the upper side toward you by 2mm so that the paper
* Shift the upper side toward you by 2mm so that the paper
edge can be seen.
13) Fix the aligned folded sides, and measure the shift quantity of
the top paper from the bottom paper.
* Right side in the figure is [+] side, and the left side [–].
14) Open the front door of the finisher, and pull out the center bind-
ing staple unit.
15) Open the open/close guide plate.
16) Turn the adjustment screw according to the measured shift
quantity in the ratio of 0.1mm/1 scale. If the shift quantity is [+],
turn it clockwise. If the shift quantity is [–], turn it counterclock-
wise.
turn it clockwise. If the shift quantity is [–], turn it counterclock-
wise.
17) Lift the adjustment screw upward, and let it fall by its own
weight.
18) Securely tighten the fixing screw which was loosened.
12. Center folding vertical shift
adjustment (MX-FNX7 only)
* If there is virtually no shift, this adjustment is not required.
(Basically no need to perform this adjustment in the market.)
1)
Set A3 paper (any paper other than black background) to the
DSPF.
DSPF.
2)
Set the staple position to the center binding.
(Do not select the image edit.)
(Do not select the image edit.)
3)
Press the copy start button, and perform center binding of one
set only.
set only.
4)
Draw an arrow mark on the paper discharged to the center
binding tray.
binding tray.
5)
Measure the shift quantity of the upper edge from the lower
edge at the center of the rear edge as shown below.
edge at the center of the rear edge as shown below.
* The right side on the figure is [–], and the left side is [+].
Open/close guide plate
Center binding
staple unit
staple unit
Fixing screw
Adjustment
screw
screw
2 mm
Shift
quantity
Fixing screw
Adjustment screw
Open/close
guide plate
guide plate
Center binding
staple unit
staple unit
Click on the first or last page to see other MX-FNX6 service manuals if exist.