Read Sharp MX-FNX6 Service Manual online
MX-FNX6 REPLACEMENT AND ADJUSTMENT 4 – 5
9. Staple paper exit sensor replacement
1)
Remove the staple paper exit sensor bracket. (1 screw)
2)
Remove the staple paper exit sensor from the bracket.
10. Punch unit replacement
Since the punch unit is adjusted in the factory before shipping,
there is no need to adjust it in the market. To replace the punch
section, replace the whole punch unit.
there is no need to adjust it in the market. To replace the punch
section, replace the whole punch unit.
1)
Remove the rear cover.
2)
Remove the horizontal resist sensor unit.
(2 connectors, 2 screws)
(2 connectors, 2 screws)
3)
Remove the punch unit slide motor bracket.
(1 connector, 2 screws)
(1 connector, 2 screws)
4)
Pull and remove the punch unit. (2 connectors)
Staple paper exit sensor bracket
Staple paper
exit sensor
Point:
Since the punch unit is adjusted precisely before shipping from the factory,
do not disassemble it.
When removing or replacing the unit, do not drop or traumatize the unit as
it may go out of adjustment.
Since the punch unit is adjusted precisely before shipping from the factory,
do not disassemble it.
When removing or replacing the unit, do not drop or traumatize the unit as
it may go out of adjustment.
Horizontal resist sensor
Punch unit slide
Punch unit
Click on the first or last page to see other MX-FNX6 service manuals if exist.