Read Sharp MX-FNX6 Service Manual online
MX-FNX6 MECHANISM 3 – 7
F. Center binding holding mechanism
(MX-FNX7 only)
In the center binding bookmaking mode, curls and slacks on paper
stacked on the staple tray are pressed to the staple tray side,
improving the paper edge detection accuracy and preventing paper
bundle shift when binding.
1)
stacked on the staple tray are pressed to the staple tray side,
improving the paper edge detection accuracy and preventing paper
bundle shift when binding.
1)
In the center binding bookmaking mode, paper is stacked to
the staple tray and vertical alignment and horizontal alignment
are completed. Then, paper bundle is transported to the center
binding stapler position at the center of the staple tray, and the
paper bundle rear edge is detected by the photo sensor.
The paper bundle is stopped according to the detection infor-
mation, and binding is performed.
the staple tray and vertical alignment and horizontal alignment
are completed. Then, paper bundle is transported to the center
binding stapler position at the center of the staple tray, and the
paper bundle rear edge is detected by the photo sensor.
The paper bundle is stopped according to the detection infor-
mation, and binding is performed.
2)
During these operations (after completion of horizontal/vertical
alignment, transport of paper bundle to the center binding posi-
tion, completion of binding - *), the holding SOL is turned ON,
and the roller is moved to the holding position via the arm to
hold the paper bundle.
alignment, transport of paper bundle to the center binding posi-
tion, completion of binding - *), the holding SOL is turned ON,
and the roller is moved to the holding position via the arm to
hold the paper bundle.
3)
After completion of binding, the holding SOL is turned OFF to
save the roller to the standby position until the next job is
started.
save the roller to the standby position until the next job is
started.
* When the paper for center binding bookmaking is A3T, B4T, DLT,
or LG size, in order to detect the paper bundle rear edge with the
photo sensor, the paper bundle is moved up and down (normal/
reverse operation) inside the staple tray. When in reverse opera-
tion (moving down), the holding SOL is turned OFF to save the
roller in order not to prevent reverse operation of the paper bun-
dle by the roller.
photo sensor, the paper bundle is moved up and down (normal/
reverse operation) inside the staple tray. When in reverse opera-
tion (moving down), the holding SOL is turned OFF to save the
roller in order not to prevent reverse operation of the paper bun-
dle by the roller.
8. Center binding staple mechanism
(MX-FNX7 only)
1)
The first set is transported to the center binding staple section.
2)
The center binding stapling of the first set is completed.
3)
The discharge fence 1 starts transport of the first set, and the
bundle branch guide pushes the first set to the transport roller
to start transport to the folding process section.
bundle branch guide pushes the first set to the transport roller
to start transport to the folding process section.
Holding SOL
Arm
Holding roller
Discharge fence 1
Center binding staple
First set paper bundle
Discharge fence 2
Discharge fence 1
Discharge fence 2
Discharge fence 2
Bundle branch guide
Discharge fence 1
Transport roller
Click on the first or last page to see other MX-FNX6 service manuals if exist.