Read Sharp MX-FD10 (serv.man3) Service Manual online
MX-7040N MX-FD10 (FOLDING UNIT) 19 – 4
D. Tilt adjustment
MEMO: When the adjuster bolt is turned counterclockwise, the
height is decreased. When turned clockwise, the height is
increased.
height is decreased. When turned clockwise, the height is
increased.
MEMO: The specification of the tilt adjustment is as follows.
Tilt: The difference of clearance between upper and lower part of
the adjacent device is within
the adjacent device is within
2mm.
1)
Turn the adjuster bolt of the caster (paper exit side) on the
front side to adjust the height.
front side to adjust the height.
2)
Turn the adjuster bolt of the caster (paper exit side) on the rear
side to adjust the height.
side to adjust the height.
E. Caster height adjustment
When the height of the paper folding unit is adjusted, execute the
caster roller height adjustment in the folder section according to the
following procedures.
caster roller height adjustment in the folder section according to the
following procedures.
1)
Open the front upper cover, pull out the folder section, remove
the screws, and remove the front cover of the folder section.
the screws, and remove the front cover of the folder section.
2)
Return the folder section to the inside of the machine. Loosen
the screws, and turn the adjuster bolt to adjust the height so
that the clearance between the caster roller and the floor is
about 1mm. After completion of the adjustment, tighten the
screw to fix.
the screws, and turn the adjuster bolt to adjust the height so
that the clearance between the caster roller and the floor is
about 1mm. After completion of the adjustment, tighten the
screw to fix.
F. Cables attachment
1)
Connect the communication cables from the folding unit to the
finisher. Fix it with the screw (Packed items No.7).
finisher. Fix it with the screw (Packed items No.7).
[1]
[2]
[1]
[2]
[1]
[2]
About 1mm
B
A
[1]
[2]
Click on the first or last page to see other MX-FD10 (serv.man3) service manuals if exist.