MX-B382 (serv.man7). INSTALLATION MANUAL - Sharp Copying Equipment Service Manual (repair manual). Page 12

MX-B382/B402  MX-B382/B402 (MAIN UNIT)  1 – 8

3)

Insert the tray slowly.
The machine automatically detects the set paper size.

4)

Close the cabinet and turn on the power.
The toner concentration adjustment operation is automatically
started, and "Please wait. Do not turn the power off." is dis-
played.
When the toner concentration adjustment operation is com-
pleted, the message of "Install the toner cartridge." is dis-
played. Do not make any operations until the message is
displayed.

* The life of each toner cartridge is as follows:

Equivalent to approximately 2.5K (A4/LT 5%)

1)

Shake the toner cartridge (included in package) horizontally
several times.

2)

Insert the toner cartridge horizontally and straight until it locks.

NOTE: Do not forcibly insert the toner cartridge. Keep holding the

cartridge and completely insert it.

NOTE: When the machine is transported with the developing unit

removed, be sure to remove the toner cartridge. (if not
toner may become clogged.)

NOTE: Do not remove or insert the toner cartridge with the devel-

oper cartridge removed.

Use SIM26 to set to the specifications according to the customer's
request.

To customize one of the following items after destination setting,
change the set value of the item.

Make a copy in the document table mode and in the RSPF mode,
and check to confirm that the void area is within the specified range
shown below.

NOTE: When an option cassette is installed, execute this adjust-

ment.

1)

Enter the SIM50-28 mode.

2)

Select [SETUP/PRINT ADJ].

3)

Select [OFFSET].

(Note)
When [ALL] is selected, the adjustments of the following two
items are performed at a same time.
* [LEAD]: Print image lead edge image position adjustment
* [OFFSET]: Print image off-center adjustment

26

6

Destination setting

26

3

Auditor specifications, mode setting

18

Toner save mode enable/disable setting (Japan and UK 
versions only)
* For the other destinations, this setting is made by the user 

program.

52

Count-up enable/disable setting of non-print paper passing for 
each counter

53

User auto calibration enable/disable setting

65

Staple limit quantity setting

ǂǂǂ6,08/$7,21ǂǂ12

&/26(

7(67

$872,0$*(326,7,21$'-8670(176(59,&(

2&$'-

%.0$*$'-

63)$'-

66(78335,17$'-

5(68/7

'$7$

ǂǂǂ6,08/$7,21ǂǂ12

&/26(

7(67

$872,0$*(326,7,21$'-8670(176(59,&(

/($'

2))6(7

$//