MX-6500N, MX-7500N (serv.man10). Installation Manual (Revised May 2017). - Sharp Copying Equipment Service Manual (repair manual). Page 17

MX-7500N  MX-7500N/6500N (MAIN UNIT)  2 – 7

8)

Shake the developer unit horizontally a few times.

9)

Insert the developer unit, and locked.

NOTE: When installing, do not insert forcibly, but insert slowly

and horizontally by putting your hand on it.

10) Close the positioning unit, and fix the screw.

11) Insert the positioning shaft, and fix the screw.

1)

With the front cover open, connect the power plug to the power
outlet.

2)

Turn ON the main power switch of the machine and the power
switch on the operation panel.

3)

Enter the SIM25-2 mode.

4)

After entering the simulation, close the front cover.

5)

Select K, C, M, Y and then press the [EXECUTE] button. The
system then performs the simulation, samples the toner den-
sity control sensor value, and sets (stores in memory) the
average sensor detection level as the control level for the ref-
erence toner density. (Operating times: approx. 3 minutes)

MEMO: Be sure to select all of the four colors: K, C, M, Y

6)

After the machine completes cycling, exit the simulation mode
by pressing the [CA] key on the main unit.

* The life of each toner cartridge is as follows:

Black toner cartridge: equivalent to approximately 65K (A4/LT
5%)

Color toner cartridge: equivalent to approximately 40K (A4/LT
5%)

NOTE: Before installing toner cartridges, install Exit Tray Unit(MX-

TR14) or Paper Pass Unit(MX-RB12), in order to avoid
installation miss of toner cartridges.

1)

Shake the toner cartridge (packed items) several times in the
arrow direction.