Read Sharp MX-5500N / MX-6200N / MX-7000N (serv.man25) Peripheral online
83
Error codes and conditions
Printing
N
OTE
:
Intermittent print quality problems are difficult to trace. Before you try to troubleshoot print quality problems, print
a test page to make sure that the MFP itself does not need servicing or adjusting.
Test page fails to print.
MFP is not ready to print
1. Make sure that the MFP is powered on and ready to print.
2. Check the MFP Control Panel for indications or messages
about the MFP status.
There is a problem with the connection
between the Fiery X3eTY2 and the MFP
between the Fiery X3eTY2 and the MFP
1. Make sure that the Fiery X3eTY2 power switch is in the
“On” position.
2. Power off/on the MFP.
3. Make sure that the Network Scanning option is available
from the MFP Control Panel.
4. Recheck that the MFP interface cable is present and
properly connected to the Fiery X3eTY2 and the MFP.
5. Recheck that the interface board is present and properly
connected to the motherboard.
6. Replace the MFP interface cable.
7. Replace the interface board.
8. If the problem persists, service the MFP.
Corrupted system software
Reinstall system software.
Faulty HDD
Replace the HDD.
If replacing the HDD does not correct the problem, make
sure you install the old HDD back in the Fiery X3eTY2.
sure you install the old HDD back in the Fiery X3eTY2.
T
ABLE
B
Fiery X3eTY2 error codes and conditions (Continued)
Symptom
Possible cause
Suggested action
Click on the first or last page to see other MX-5500N / MX-6200N / MX-7000N (serv.man25) service manuals if exist.