Read Sharp MX-5500N / MX-6200N / MX-7000N (serv.man19) Peripheral online
MX-FNX4 DISASSEMBLY AND ASSEMBLY 6 – 65
2) Hold the pawl of the two tie wraps with lock [1], and remove
them. (Remove without cutting the tie wraps.)
3) Disconnect the three connectors [2].
4) Remove harness [4] from the three harness holders [3].
4) Remove harness [4] from the three harness holders [3].
5) Turn the gear [1] into the arrow direction, and move the punch
module [2] to the front side.
6) Remove the three screws [1] and the sensor base (upper) [2].
7) Then, disconnect the connector of the photo sensor PCB [3]
7) Then, disconnect the connector of the photo sensor PCB [3]
and the connector of the LED PCB [4], and remove the har-
ness from the edge saddle [5].
ness from the edge saddle [5].
8)
Remove the harness [2] from the four harness holders [1].
9)
Disconnect the connector of the horizontal registration motor
[1] and the connector of the horizontal registration sensor [2],
and remove the punch module harness.
[1] and the connector of the horizontal registration sensor [2],
and remove the punch module harness.
[2]
[1]
[2]
[3]
[3]
[1]
[3]
[4]
[1]
[2]
[2]
[1]
[1]
[3]
[1]
[1]
[2]
[1]
[2]
[1]
Click on the first or last page to see other MX-5500N / MX-6200N / MX-7000N (serv.man19) service manuals if exist.